HP Cooktop 10GBE manual Component identification, 10GbE Pass-Thru Module front panel, Resets

Page 7

Component identification

10GbE Pass-Thru Module front panel

		CAUTION: If you press the Reset button while the Health LED is green, the pass-thru module
		resets.


Item	Description

1	UID LED
	• Blue light on—The pass-thru module is activated.
	• Blue light off—The pass-thru module is deactivated.

2	Health LED
	• Off—The pass-thru module is powered off.
	• Green—The pass-thru module is powered up, and all ports
		match.
	• Amber—An issue exists, such as a port mismatch. For more
		information, see the HP BladeSystem Enclosure Setup and
		Installation Guide.

3	Ethernet port
	•	Green—Link is 10G.
	• Flashing green—10G link activity is detected.
	•	Amber—Link is 1G.
	• Flashing amber—1G link activity is detected.
	• Flashing alternately green and amber—A link mismatch
		condition exists. For more information, see the HP BladeSystem
		Enclosure Setup and Installation Guide.
			Component identification 7
			Component identification 7

Image 7

Contents Part Number December 2010 Second Edition 10GbE Pass-Thru Module User GuideIntended audience Contents Electrostatic discharge Introduction FeaturesPass-thru module architecture Port mapping Dual pass-thru modules XModemRedundant paths to server bays Description ResetsComponent identification 10GbE Pass-Thru Module front panelDescription Module security Installing the pass-thru moduleManually configuring the pass-thru module Installing the moduleAccessing the pass-thru module CLI remotely Accessing the pass-thru module CLICLI menu Accessing the pass-thru module CLI locallyProduction mode CLI Command ResultInstalling SFP+ transceivers Replacing an existing module Replacing a pass-thru moduleMethods for updating the 10GbE Pass-Thru Module firmware Updating the 10GbE pass-thru firmwareEnter y. The following message appears Enter C. The following message appearsEnter R. The following message appears Enter N. The following message appearsEnter x. The following message appears Configuration Script Files Usb//d1/test.cfg Performing a serial firmware image download Updating the firmware image using the serial portBaud rate 9600 Data bits Parity None Stop bits Flow control Additional references For more informationHealth LED on the pass-thru module is not on TroubleshootingCause Action Try another mini-USB to DB-9 RS232 cable SFP+ transceiver port is disabled Pass-thru module configuration is corruptDownload fails after starting to download the firmware file Port names Technical specificationsGeneral specifications Category SpecificationFrom Wire Physical and environmental specificationsMini-USB to DB-9 serial adapter pin assignment Shell Braid Technical specifications Regulatory compliance notices Regulatory compliance notices Regulatory compliance notices Preventing electrostatic discharge Electrostatic dischargeGrounding methods to prevent electrostatic discharge Acronyms and abbreviations Local-area network Media Access ControlNetwork access server Power-On Self TestIndex Index