oDefault for NC6170 and NC7170 adapters = No Action
oRange for NC6170 and NC7170 adapters = Disabled; Enabled; Hardware Default; No Action
•Flow Control. Determines the type of flow control that is needed. Flow control enables the transmission of PAUSE frames. Not supported on NC71xx adapters.
oDefault = Rx/Tx Enable
oRange = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
•Gigabit Master Slave Mode. Determines IEEE 802.3ab
oDefault = Auto Detect
oRange = Auto Detect; Force Master Mode; Force Slave Mode
•Interrupt moderation. If enabled, helps to reduce number of interrupts per packet, which reduces CPU utilization, while maintaining the same throughput. This feature is useful under heavy network traffic conditions.
oDefault = Enabled
oRange = Disabled; Enabled
•Interrupt moderation rate. Determines the amount of interrupts per second when the Interrupt moderation parameter is enabled.
oDefault = Adaptive
oRange = Adaptive; Extreme; High; Low; Medium; Minimal; Off
•IPv4 Checksum Offload. Describes whether the device enabled or disabled the calculation of IPv4 checksums.
oDefault = Rx/Tx Enable
oRange = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
•Jumbo Packet. The size, in bytes, of the largest supported Jumbo Packet (an Ethernet frame that is greater than 1514 bytes) that the hardware can support.
oDefault = Disabled
oRange = 4088 Bytes; 9014 Bytes; Disabled
•Large Send Offload Version 2 (IPv4). Describes whether the device enabled or disabled the segmentation of large TCP packets over IPv4 for large send offload version 2 (LSOv2).
oDefault = Enabled
oRange = Disabled; Enabled
•Large Send Offload Version 2 (IPv6). Describes whether the device enabled or disabled the segmentation of large TCP packets over IPv6 for large send offload version 2 (LSOv2).
oDefault = Enabled
oRange = Disabled; Enabled
•Link Speed & Duplex. Sets the connection speed to the network and mode.
oDefault = Auto Negotiation
oRange for NC340x and NC71xx adapters: Auto Negotiation;