HP 441877-00F manual Adapter configurations

o1 Gb Full Auto. Sets the speed to 1 Gbps and mode to Full-Duplex

o10 Mb Full. Sets the speed to 10 Mbps and mode to Full-Duplex

o10 Mb Half. Sets the speed to 10 Mbps and mode to Half-Duplex

o100 Mb Full. Sets the speed to 100 Mbps and mode to Full-Duplex

o100 Mb Half. Sets the speed to 100 Mbps and mode to Half-Duplex

oAuto. (Default) Sets the speed and mode for optimum network connection (recommended)

•TCP/UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of TCP or UDP checksum over IPv4 packets. If this TCP/UDP Checksum Offload (IPv4) property is present, it overrides the TCP Checksum Offload (IPv4) and UDP Checksum Offload (IPv4) properties and they are disabled.

oDefault = Rx/Tx Enabled

oRange = Disable; Tx Enable; Rx Enable; Rx/Tx Enabled

•TCP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of TCP Checksum over IPv4 packets.

oDefault = Rx/Tx Enable

oRange = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

•UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of UDP checksum over IPv4 packets.

oDefault = Rx/Tx Enable

oRange = Disable; Tx Enable; Rx Enable; Rx/Tx Enable

•VLAN ID. The user assigned identifier for a VLAN.

oRange: 1–4094

•Wake Up Capabilities. Determines the type of packets that will cause the adapter to wake up the system.

oDefault = Both

oRange = Both; Magic Packet; None; Wake Up Frame

•WOL Speed. (Not supported on NC150T, NC37x, NC380T, NC67xx, and NC7782 adapters) Specifies the speed at which the adapter connects to the network during Wake-on-LAN mode.

oDefault = Auto

oRange = Auto; 10 Mb; 100 Mb Multifunction Gigabit Server adapter properties

•iSCSI VLAN. Allows you to create a VLAN for an iSCSI-enabled device.

•Receive-Side Scaling (RSS). Enables dynamic load balancing of incoming traffic across CPUs. Microsoft Scalable Networking Pack (SNP) is required when enabling TOE and RSS.

oDefault = Enable

oRange = Enable; Disable

Adapter configurations 31