HP 441877-00F manual Parameter Options Description

Parameter	Options	Description
CheckSum =	Default = ON	Enables or disables the transmit and receive
	Selections are: ON, OFF, Tx,	checksum off-loading feature. Checksum is
		supported under NetWare 5.x only. If you
	Rx
		want to enable the CheckSum parameter, you
		need to load it on the first instance.
Frame = type	Valid types are:	Defines the frame type being used by this load
	Ethernet_802.2,	instance. Ethernet_802.2 and Ethernet_II are
	Ethernet_802.3, Ethernet_II,	the default values.
	Ethernet_SNAP
node =	NNNNNNNNNNNN	Specifies a node address in this field to
		override the default Media Access Controller
		(MAC) address (also known as the Locally
		Administered Address)
name = text		Displays the name assigned to this adapter
PDriver =	Default = OFF	Allows driver to operate in persistent driver
	Selections are: OFF, ON	mode. Persistent driver mode is supported
		under NetWare 5.x only. Use only if adapter
		is placed in a Hot Plug PCI slot and only if
		required to swap with an exact board.
RxBuffers =	Default = 200	Pre-allocates ECB resources on the adapter for
	Recommended Min = 32	receiving packets
	Max = 512
	Min = 1 when used with DOS
	Client32 and when Keywrod
	P3-1 or 2.
TxDescriptors =	Default = 200	Pre-allocates ECB resources on the adapter for
	Recommended Min = 100	transmitting packets.
	Max = 512
	Min = 1 when
	used with DOS
	Client32 and when
	Keywrod P3-1 or
	2.
RxFlow =	Default = OFF	Allows enabling/disabling of RxFlow control.
	Selections are: ON, OFF
TxFlow =	Default = OFF	Allows enabling/disabling of TxFlow control.
	Selections are: ON, OFF
Slot = n		Identifies the slot number for the specific
		adapter currently being configured. This
		parameter is not necessary if only a single
		adapter is installed.
Speed = n		If link negotiation has been disabled, specifies
		port speed to be either Auto, 10HD or 10FD,
		100HD or 100FD.

Installation 13