INSTALLATION
1. Add Jumper At Remote 3-Way Switch.
A jumper wire between the common wire and one of the switched wires is used to supply power to the
❐Remove remote switch from the junction box.
The switch may
indicate the
common
OR
Color of screw may be different for the common
To Red wire of
(note color)
Common Switch Lug
COMMON
Hot Wire
Jumper
To brown wire of
Connect Jumper at the Remote Switch
❐Connect the jumper wire to the common lug (usually labeled on the switch) and to either one of the two switched lugs. If you're not sure which lug is common, install the jumper on any two of the wires, and test the jumper as explained on the next page.