Heath Zenith SL-6107 manual Troubleshooting Wiring Connections, Turn power off before rewiring

INSTALLATION

❐Mount the SL-6107 into the junction box with the two junction box screws.

❐Turn the circuit breaker back on.

❐Preset the controls: Time to min. (fully counter-clockwise), Photo Adjustment fully clockwise. Cover the lens with masking tape.

❐With the motion sensor in the “ON” position, turn the remote switch on and off several times. Go to step 1, 2, or 3, depending on results.

Troubleshooting Wiring Connections

* Turn power off before rewiring!

1.

2.

If light does not turn on:

If light turns on in only one position of remote switch:

➯

➯

Exchange*

Control's

Red ⇔ Black

wires.

Exchange*

Control's

Red ⇔ Brown

wires.

➯

➯

Test again. Go

to 2 or 3.

Test again. Go

to 1 or 3.

3.

If light turns on

with remote

switch in either

position:

➯

Set sensor to “AUTO”. Wait for the unit to warm up (up to 1 min.). If the remote switch can turn the lights on, it's OK. Otherwise:

➯

Exchange* Control's

Black ⇔ Brown wires. Remove the tape. Go to the next page.

595-4514-13-7-