INSTALLATION
❐Mount the
❐Turn the circuit breaker back on.
❐Preset the controls: Time to minutes, Photo Adjustment fully clockwise. Cover the lens with masking tape.
❐With the motion sensor in the “ON” position, turn the remote switch on and off several times. Go to step 1, 2, or 3, depending on results.
Troubleshooting Wiring Connections
* Turn power off before rewiring!
1.
2.
If light does not
turn on:
If light turns on in only one position of remote switch:
➯
➯
Exchange*
Control’s
Red ⇔ Black
wires.
Exchange*
Control’s
Red ⇔ Brown
wires.
➯
➯
Test again. Go
to 2 or 3.
Test again. Go
to 1 or 3.
3.
If light turns
on with remote switch in either position:
➯
Set sensor to “AUTO”. Wait for the unit to warm up (up to 1 min.). If the remote switch can turn the lights on, it’s OK. Otherwise:
➯
Exchange* Control’s
Black ⇔ Brown wires. Remove the tape. Go to the next page.
- - |