Rinnai RHFE-750ETRA installation manual Correct Floor

Page 19

Location

Use the adjustment feet so that the appliance is level and not tilted. They are initially installed immediately behind the side louvers but can be moved forward for better access in hearth or floor installations.

The hearth should not block the appliance from being rolled out nor should it prevent the front panel from being installed or removed.

Wall Lining

Correct Floor

Level Installation

Adjustment

feet

Floor (Timber, Concrete, Tile, etc.)

	Correct Hearth
	Installation
	Hearth	Adjustment
	Hearth	feet
		feet

Wall Lining

Particle Board, MDF, Plywood etc.

Correct In-wall

Installation

Adjustment

feet

Wall Lining

Particle Board, MDF, Plywood etc.

Incorrect Hearth

Installation

Hearth

Adjustment

feet

Incorrect Hearth

Installation

Hearth	Adjustment
	feet

Wall Lining

Particle Board, MDF, Plywood etc.

Wall Lining

Particle Board, MDF, Plywood etc.

Rinnai Corporation RHFE-750ETRA

19

Image 19

Contents RHFE-750ETRA Table of Contents Safety Behavior and Practices Safety Features Natural Gas Propane Gas SpecificationsDimensions FeaturesFront Panel Models Front PanelDescription Part Number Remote Control Care Remote Control FeaturesTurning on and OFF Remote Control OperationSequence of Operations Basic Fireplace OperationsLock Function Adjusting the TemperatureFlame Function Obstruction of Warm Air DischargePre-heat TimersProgramming the clock and timers Using the OverrideVisual Inspection of Flame Care and MaintenanceMaintenance FiltersCare of Exterior Cleaning Combustion Chamber GlassProblem Possible Solutions or Explanation TroubleshootingReplacement of Thermal Fuse Fault CodesCode Fault Remedy General Instructions Parts Included for InstallationClearances for a Mantle or Decorative Overhang Clearances to CombustiblesFlue Terminal Clearances Side clearances for air ventsDescription Canadian Installations US Installations 28.3 in 720 mm LocationCorrect Floor Drilling Flue and Gas Supply Holes Flue Manifold InstallationVenting Venting with Flue Manifolds FOT-203 and FOT-204+ c II. Extended Venting Horizontal and Vertical Terminations Part Description Number Manufacturer Metal-FabMaximum Length = 33 feet 10 m and 3 elbows Additional Venting Clearances Vent Length SwitchConnections Mounting points Install the Logs Final AssemblyCondensate Tray Air Guide Vanes Install the Front PanelOperating Instructions For Your Safety Read Before OperatingWiring and Schematic Diagrams Parts List Parts List 109 QTY Description Comments NG Left and Right Packing for AIR Inlet BOX RHFE-750ETRA Direct Vent Fireplace Warranty InformationLimited Warranty What is covered?What will Rinnai do? How do I get service? What is not covered?Limitation on warranties Issue G