Basic Fireplace Operations
Adjusting the Temperature
Pressing the UP and DOWN buttons will change the temperature setting by 2 degree (F) increments. The display will show “Temperature” and the new temperature as
Flame Function
Press the FLAME button to control the flame Flame level. There are seven levels of flame
available.
confirmation.
The temperature can be set to:
• L (Low) - burner is on minimum combustion
• 60° F - 80° F in two degree increments
Temperature | • H (High) - burner is |
on maximum combustion |
To use Celsius scale,
Flame
AM
Time
The display will show the word “Flame” and a series of short bars (one for each flame level).
Use the UP or DOWN buttons to select the desired flame level.
Pressing the FLAME button again will allow the appliance to control the flame automatically.
open the battery compartment and move the switch toward “0”.
The temperatures
Obstruction of Warm Air Discharge
Obstructing the louvers for the warm air discharge will cause the appliance to operate inefficiently.
When an obstruction is detected the Blockage Indicator LED above the Receiver Window will glow red and combustion reduces to front burner, low operation only.
To restore normal operation, remove the obstruction, turn the appliance OFF and then ON.
Lock Function
Pressing the LOCK button will cause all Lock functions of the remote control to be locked
except for the STANDBY/ON button.
Lock | The remote control |
display will show the word | |
AM | “Lock” in the top left |
| corner. |
Time To cancel the Lock function press down and hold the LOCK button for 3 seconds.
If the room temperature reaches 104° F (40° C) while the flame function is on then the appliance will turn off automatically as a safety precaution.
The FLAME function is not available during TIMER operation.
Auto Off Function
Auto | When the appliance is not in AUTO OFF | ||
mode and the room temperature reaches | |||
Off | the temperature setting the appliance will | ||
|
| reduce the gas flow and | |
| Auto Off | maintain the flame on | |
AM | the lowest flame level. | ||
| |||
| The temperature may | ||
|
| continue to rise even on | |
| Time | this low setting. If the | |
|
| temperature reaches | |
104° F (40° C) then the appliance will automatically shut down with fault code 16.
When the temperature setting is reached while the appliance is in AUTO OFF mode, the gas flow will be reduced to pilot operation and the convection fan will run on low speed. To enter this mode press the AUTO OFF button. The words “Auto Off” will be displayed above the time. To exit this mode press the AUTO OFF again.
Whether this mode is on or off, the appliance will attempt to maintain the temperature setting.
Rinnai Corporation | 9 |