Omega Speaker Systems FPU5-MT-110, FPU5-MT-220 manual Total Volume Mode

Table 6-4 TOTAL VOLUME MODE

	KEY		DISPLAY	ACTION TAKEN
			SHOWS	AND PROCEDURE
ON/OFF Switch			xxx mL	Pump motor’s power
			or	NOTE: if you turn off the pump motor’s power, the pump stops
			xxx Liters
				running.
				To continue pumping, turn on the unit’s power. The display
				returns to the STOPPED Display Mode and shows the volume of
				fluid dispensed during pumping. Then press the START/STOP
				key.
			xxx mL	Pump(s) stops; press again pump(s) starts
		START
		STOP	or
				To resume pumping for the remainder of the TOTAL VOLUME
			xxx Liters	setting, press the START/STOP key. The display enters the
				RUNNING Display Mode, and the fluid begins to dispense.
			Must STOP first!	LEDs indicate new pump direction
	INLET
	SELECT
				To select the other inlet and reverse the direction of pumping:

1.Press the START/STOP key. The display returns to the STOPPED Display Mode.

2.Press the INLET SELECT key to reverse the direction of pumping.

3.Press the START/STOP key again to resume pumping.

4.For detailed instructions on “Defining the Direction of Pumping, refer to Section 5.2.

	STOP to Prime...	Pumps fluid at current rpm or flow rate
PRIME		setting as long as the key is pressed

To prime a tube:

1.Press the START/STOP key to stop the pump. The display returns to the STOPPED Display Mode.

2.Press and hold down the PRIME key to prime the tube.

3.Press the START/STOP key again to resume pumping.

4.For detailed instructions on “Priming a Tube”, refer to Section 5.4.

xxx °C Display alternates when pressed, °C then °F.

TEMP

NOTE: The TEMP key functions the same whether the pump is stopped or running. Refer to Section 5.6.

	Displays actual RPM
RPM	xxx rpm
	Press the RPM key. The display flashes the actual pump motor
	speed (xxx rpm).
	Displays cumulative TIME since start
TIME	xx:xx:xx

Press the TIME key. The display flashes the time that the pump has been running (xx:xx:xx:).

6-19