Omega Speaker Systems FPU5-MT-110, FPU5-MT-220 manual Pumping in the Time Mode

Operating the Pump Motor in the RUNNING Display Mode 6

6.3 The TIME Mode

Figure 6-5 shows the overall block diagram of the TIME Mode in the

RUNNING Display Mode.

TUBE ID	CURRENT			TUBE ID SETTING
	TUBE ID	OR		TO BE USED IN
	SETTING			PUMPING
	CURRENT		FLOW RATE		(Refer to Section 5.5)
FLOW
	FLOW RATE			SETTING	CALIBRATE
RATE	SETTING	OR	TO BE USED IN
				PUMPING
					(Optional)
			RPM SETTING TO BE		(Refer to Section 5.5)
	CURRENT
RPM		OR	USED IN PUMPING		CALIBRATE
	RPM
	SETTING				(Optional)
STOPPED
DISPLAY
MODE
	CURRENT			TIME SETTING
TIME	TIME SETTING		TIME
				TO BE USED IN
		and			PUMPING
		OR
(Time Runs Out)
	TIME ELAPSED	RUNNING
START	DURING PUMPING	DISPLAY			START
STOP					STOP
(Forced Stop)		MODE

Figure 6-5. Block Diagram: Pumping in the TIME Mode

In the TIME Mode, you pump fluid at a certain motor speed or flow rate, for a particular amount of time. The pump motor uses the RPM or FLOW RATE setting. It measures the volume of fluid dispensed, but ignores the TOTAL VOLUME setting.

6.3.1 Pumping in the TIME Mode

To pump fluid in the TIME Mode, do the following:

1.Set up the pump motor for pumping according to Chapter 3.

2.Toggle the ON/OFF switch to turn on the unit’s power. The display is in the STOPPED Display Mode. Refer to Figure 6-5.

3.Using the procedure outlined in Sections 6.1.1. and 6.2.1, adjust either the RPM or FLOW RATE setting.

6-11