Omega Speaker Systems FPU5-MT-110 manual Pumping in the Total Volume Mode, Total Volume Range

Operating the Pump Motor in the RUNNING Display Mode 6

6.4.1 Pumping in the TOTAL VOLUME Mode

To pump fluid in the TOTAL VOLUME Mode, do the following:

1.Set up the pump motor for pumping, according to Chapter 3.

2.Toggle the ON/OFF switch to turn on the unit’s power. The display is in the STOPPED Display Mode. Refer to Figure 6-7.

3.Using the procedure outlined in Sections 6.1.1. and 6.2.1, adjust either the RPM or FLOW RATE setting.

4.When the display flashes the RPM or FLOW RATE setting you desire, press the TOTAL VOLUME key.

TOTAL

VOLUME

Display shows

xxx mL or xxx Liters

ACTION

Displays current

TOTAL VOLUME

setting

The display flashes the current TOTAL VOLUME setting (xxx mL or xxx Liters).

5.Use the UP and DOWN ARROW keys to enter the TOTAL VOLUME setting you desire. Refer to Figure 6-8 for the TOTAL VOLUME range.

	
Display shows	Display shows
xxx mL or xxx Liters	xxx mL or xxx Liters
ACTION	ACTION
TOTAL VOLUME setting scrolls up	TOTAL VOLUME setting scrolls down
Range	Range
	
1 mL	10,000 L

	2 mL			9,999 L
.		.
	999 mL		1,000 mL (1L)
1,000 mL (1 L)				999 mL
.		.
	9,999 L			2 mL
	10,000 L			1 mL

Figure 6-8. TOTAL VOLUME Range

6-17