Samsung SNC-C7478P manual Preset Setup, Edit Preset Scene, Edit Preset Label, Cancel/Ok

How to use OSD Menu

PRESET Setup

PRESET SETUP
PRESET NO.	1
<EDIT SCENE>
<LABEL>	WINDOWS
CLR PRESET	CANCEL
CAM ADJUST	GENERAL
ALARM OUT	----

BACK

EXIT

• Preset Number [1~128]

If a selected preset is already defined, camera moves to pre-defined position and preset characteristics such as Label and Relay Outputs show on monitor. If a selected preset is not defined, “UNDEFINED” shows on monitor.

•Edit Preset Scene

Redefine current Preset scene position (i.e. PTZ).

•Edit Preset Label

Edits Label to show on monitor when preset runs. MAX. 10 alphabets are allowed.

• CLR Preset	[CANCEL/OK]
Delete current Preset data
• CAM Adjust	[GENERAL/SPECIAL]

WB(White Balance) and AE(Auto Exposure) can be set up independently for each preset. There are 2 modes, “General” mode & “Special” mode. The General mode means that WB or AE can be set up totally and simultaneously for all presets in “CAMERA SETUP” menu.

The Special mode means that WB or AE can be set up independently or separately for each preset in each preset setup menu. Each Special WB/AE value should activate correspondingly when camera arrives at each preset location. During jog operation, General WB/AE value should be applied.

All Special WB/AE value should not change although General WB/AE value changes. If “Special’’ is selected, Menu to set WB/AE shows on monitor.

•Alarm out

State of four alarm outputs can be freely controlled in conjunction with Preset run. The character “-“ means OFF state and the number representing each bit means ON.

Ex) If it is set to be -23-, Output relay 2, 3 will be ON and 1, 4 will be OFF, when you run this Preset.

❖Edit Preset Scene

EDIT SCENE - PRESET 1

MOVE TO TARGET POSITION [NEAR:SELECT / FAR:CANCEL] 0/0/x1/N

Using joystick, move camera to desired position.

By pressing NEAR or ENTER key, save current PTZ data.

Press FAR key to cancel.

❖Edit Preset Label

LABEL - PRESET 1

[█]

----------

1234567890 OK ABCDEFGHIJ CANCEL KLMNOPQRST UVWXYZabcd efghijklmn opqrstuvwx yz<>-/:.

Edits label to show on monitor when camera arrives at presets. In Edit Label menu, a reverse rectangular is cursor. As soon as finishing selecting alphabet, cursor moves to the next digit.

 [ ]

Current Cursor Position

Using Left/Right/Up/Down of joystick, move to an appropriate character from the Character set. To choose that character, press the NEAR or ENTER key.

English – 23