Samsung SNC-C7478P manual Auto Pan Setup, Pattern Setup, Back Space Char

How to use OSD Menu

Back Space Char.

Space Char.

If you want to use blank, choose Space character (“ ”). If you want to delete a character before, use back space character (“”).

If you complete the Label editing, move cursor to “OK” and press NEAR or ENTER key to save completed label. To abort current change, move cursor to “Cancel” and press NEAR or ENTER key.

Auto Pan Setup

AUTO PAN SETUP
APAN NO.	1
1ST POS.	NOT USED
2ND POS.	NOT USED
APAN SPEED	30/SEC
CLEAR APAN	CANCEL

BACK

EXIT

• Auto Pan Number [1~8]

Selects Auto Pan number to edit. If a selected Auto Pan has not defined, “NOT USED” is displayed in 1st Position and 2nd Position

• 1st Position / 2nd Position [PRESET 1~128]

Set up the 2 position for Auto Pan function. If a selected preset is not defined, “UNDEFINED” will be displayed as shown below.

AUTO PAN SETUP
APAN NO.	1
1ST POS.	PRESET5
2ND POS.	PRESET8
	UNDEFINED

When Auto Pan function runs, camera moves from the preset assigned as the 1st point to the preset assigned as the 2nd point in CW(Clockwise) direction. Then camera moves from the preset assigned as the 2nd point to the preset assigned as the 1st point in CCW(Counterclockwise) direction. In case that the preset assigned as the 1st point is same as the preset assigned as the 2nd point, camera turns on its axis by 360° in CW direction and then it turns on its axis by 360° in CCW direction.

•APAN(AUTO PAN) Speed [1°/sec ~180°/sec] Sets Auto Pan speed from 1°/sec to 180°/sec.

• Clear APAN(AUTO PAN) [CANCEL/OK] Deletes current Auto Pan data.

Pattern Setup

PATTERN SETUP

PATTERN NO. 1 UNDEFINED

CLEAR PATTERN CANCEL <EDIT PATTERN>

BACK

EXIT

• Pattern Number [1~4 ]

Selects Pattern number to edit.

If a selected pattern number is not defined, “UNDEFINED” will be displayed under selected pattern number.

• Clear Pattern [CANCEL/OK]

Deletes data in current pattern

•Edit Pattern

Starts editing pattern.

24 – 36x IP Smart Dome Camera