Samsung SNC-C7478P manual Software Update, Reset, Https

Setup Tool

SOFTWARE UPDATE

❖Current Version

•Shows the current firmware version.

❖How to upgrade

•Click [Browse…] button and select the latest version of the firmware. Its file name should be Example) SNC-C7478_V01_090206.tgz.

•Click [Install] button. The file is uncompressed and the software update begins. Software update may take tens of minutes. To cancel an update, click the [Cancel] button.

•When the software update is done, the system will automatically restart. Since the current connection is disconnected, you have to connect to the system again.

M  Since, if the network is disconnected, the power fails or the PC abnormally operates during a software update, the system may not work afterwards. Care must be taken not to cause a problem during an update.

RESET

❖Reset

•Re-boots IP Smart Dome Camera.

❖Factory Default

•Reset system configurations to the factory defaults with following two options.

Except Network Parameter: Reset except values on Network Parameters

(IP Address, Gateway, Subnet Mask, DNS Server and Ports)

All: Reset all system configurations

M  After reset and restart, you have to connect to the system again.

It takes a few minutes until the system booting is completed. You cannot connect to the system until the system booting is complete.

After running <Factory Default> ➝ <All>, you have to run <IP Installer.exe> program and setup network settings such as IP address, Subnet mask, Gateway, etc., to connect to the Internet.

HTTPS

❖Connection Policy

•Connection policy can be selected from <HTTP>, <HTTPS with Self-Certificate>, <HTTPS with Certificate from Authority (CA)>.

To use HTTPS with Certificate from Authority for connection policy, you need to install a signed certificate issued from certificate authority in advance.

❖Install Certificate

•To install the certificate to camera, you need type Certificate Name (it can be arbitrarily assigned by user), Certificate file issued from authority and a key file. After completion, press [Install] button.

If certificate is installed successfully, the summarized status of Installed Certificate will be displayed. Also, the option button written as ‘HTTPS with Certificate from Certificate Authority’ in the above becomes activated to be selected.

M  To connect the camera using HTTPS mode, you have to type IP address of camera as “https://<Camera_IP>”.

44 – 36x IP Smart Dome Camera