Samsung SNC-C7478P manual Motion, To set a motion detection target area

Setup Tool

Email(SMTP) or saved on the SDHC memory card according to the <EVENT> ➝ <TRANSFER SETUP> settings.

<Camera Action>: Counteraction of camera when Alarm Input event occurs can be selected from <None>, <Preset 1 ~ 128>, <Pattern 1 ~ 4>, <AutoPan 1 ~ 8>, <Scan 1 ~ 8>, <Home Position>.

MOTION

❖M.D Function

• Enable/Disable

M  Even though Motion Detection is set to be enabled, this function is not working during PTZ, focus or Iris operations.

For reliable performance, it takes about 1 or 2 seconds for Motion Detection to return to work after PTZ, Focus, Iris operation.

Even if camera is subjected to external shocks or winds, those can be considered as motion detection.

❖Motion Configuration

•You can set motion detection performance parameters.

❖Motion Sensitivity

•Select a motion detection function sensitivity from <High>, <Medium> and <Low>. The <High> option provides high sensitivity of motion detection and generates motion detection event if a small motion is detected.

❖Motion Area

•You can set an area to detect motion.

❖Activation Time

•You can set time to accept a motion detection to take an action.

<Always>: Always conducts the <Action> setting when a motion is detected.

<Only Scheduled Time> : Conducts the <Action> setting for a motion detection only when it occurs during the specified time period on the specified day of the week. The Start Time must prior to and must differ from the End Time.

❖Action

•You can set an operation to be conducted when a motion is detected.

<Alarm Output> : Determines a motion detection output port to which the alarm signal is to be sent. <Output Duration>: Determines the period of time to output the alarm signal to the specified alarm output port when a motion is detected. If another detection event is generated during the alarm output, the delay time is recalculated on the basis of the most recently generated motion detection. <Alarm Image Transfer>: If <On> is selected, a JPG image is transmitted through FTP or Email (SMTP) according to the <EVENT> ➝ <TRANSFER SETUP> settings.

To set a motion detection target area

You can set a specific area to detect a motion in.

1)In the MOTION window, click the [Motion Area] button.

-The Motion Area window appears.

-You can set a specific area to detect a motion in.

2)Click over square boxes corresponding to your desired motion detection target area.

-The selected area is colored in yellow.

3)To cancel a selection, click over the square box once again.

-The square box returns to its original color.

4)To complete the setting, click the [Apply] button.

-The settings are saved.

-The motions in the selected area will be detected.

English – 47