Accessories
• The flare nuts are attached to the end of each pipe of an evaporator or a service port. Use the nuts when connecting the pipes.
•The assembly cable is optional. If it is not supplied, use the standard cable.
•The drain plug and rubber leg are only included when the air conditioner is supplied without the assembly pipe as seen in the picture below.
Optional accessories
The following connection accessories are optional. If they are not supplied, you should obtain them before installing the air
conditioner. |
|
|
|
|
|
|
Insulated | Insulated Assembly Pipe, | Insulated Assembly Pipe, | Insulated Assembly Pipe, | PE T3 Foam Tube | Vinyl Tapes (2) | Putty 100g (1) |
Assembly Pipe, | Ø9.52mm x 5 m (1) | Ø12.70mm x 5 m (1) | Ø15.88 mm x 5 m (1) | Insulation (1) | ||
Ø6.35mm x 5 m (1) | 09/12 | 18 | 24 |
|
| |
|
|
| ||||
Pipe Clamps A (3) | Pipe Clamps B (3) | Cement Nails (6) | M4 x 25 Tapped | Drain Hose, | Drain Plug (1) |
|
Screws (6) | length 2m (1) |
| ||||
|
|
|
|
| ||
|
|
|
|
| ||
Assembly Cable (2) | Assembly Cable (1) |
|
|
|
|
|
• If these accessories are supplied, they will be in the accessory box.
Tools required for installation
General Tools
• Vacuum Pump(Backward flowing prevention) | • Manifold Gauge | • Stud Finder | ||
• Torque Wrench | • Pipe Cutter | • Reamer | • Pipe Bender | • Spirit Level |
• Screw Driver | • Spanner | • Drill | • L Wrench | • Measuring Tape |
Tools for test operations
• Thermometer | • Resistance Meter • Electroscope |
07 INSTALLATION
English-37
A3050 MG Model
2014/6/10 15:48:14