How to connect your extended power cables
Items to prepare
(compressor and insulation tape should be prepared by an installation technician.)
Tools | Crimping pliers | Connection sleeve (mm) | Insulation tape | Contraction tube (mm) |
Spec | 20xØ7.0(HxOD) | Width 18 mm | 50xØ8.0(LxOD) | |
Shape |
|
|
|
|
07 INSTALLATION
1.As shown in the figure, peel off the shields from the rubber/wire of the power cable.
- Peel off 20 mm of the wire shields of the tube installed already.
• After peeling off the tube wire, you must insert a contraction tube.
2.Insert both sides of core wire of the power cable into the connection sleeve.
3.Using a compressor, compress the two points and flip it over
and compress another two points in the same location.
-The compression dimension should be 8.0.
-After compressing it, pull both sides of the wire to make sure it is firmly pressed.
4.Wrap it with the insulation tape twice and position your contraction tube in the middle of the insulation tape.
5.Apply heat to the contraction tube to contract it.
(Unit: mm)
Power cable (provided by us)
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
20 |
| 20 |
| 20 |
60 120
180
Wire tube power cable
20
Connection sleeve
Comp. dim.
Compress it 4 times
5 mm
Insulation tape
40 mm 
Contraction tube
6. After tube contraction work is completed, wrap it with the | Insulation tape | |
insulation tape to finish. | ||
|
• In case of extending the electric wire, please DO NOT use a
English-57
A3050 MG Model
2014/4/2 9:50:04