Quadra-Fire 7023-111E, CASTILE-GAS-MBK, CASTILE-GAS-CSB, CASTILE-GAS-PMH Check for GAS Leaks

WARNING

Fire or Explosion Hazard

•Gas build-up during line purge may ignite.

•Purge should be performed by qualifi ed technician.

•Ensure adequate ventilation.

• Ensure there are no ignition sources such as sparks or open fl ame.

•A small amount of air will be in the gas supply lines. When fi rst lighting appliance it will take a short time for air to purge from lines. When purging is complete the appliance will light and operate normally.

Air only needs to be purged again if gas valve has been turned to the OFF position.

WARNING

CHECK FOR GAS LEAKS

Explosion Risk

Fire Risk

Asphyxiation Risk

•Check all fi ttings and connections.

•Do not use open fl ame.

•After the gas line installation is complete, all connections must be tightened and checked for leaks with a commercially-available, non-corrosive leak check solution. Be sure to rinse off all leak check solution following testing.

Fittings and connections may have loosened during shipping and handling.

WARNING

Fire hazard.

Do NOT change the valve settings.

•This valve has been preset at the factory.

•Changing valve settings may result in fire hazard or bodily injury.

Omni-Test Laboratories listed gas appliances are tested and approved without requiring changes for elevations from 0 to 2000 feet in the U.S.A. and 0 to 4500 feet in Canada.

When installing this appliance at an elevation above 2000 feet, it may be necessary to decrease the input rating by changing the existing burner orifi ce to a smaller size. Input rate should be reduced by 4% for each 1000 feet above a 2000 foot elevation in the U.S.A. If the heating value of the gas has been reduced, these rules do not apply. To identify the proper orifi ce size, check with the local gas utility.

If installing this appliance at an elevation above 4500 feet (in Canada), check with local authorities.

Page 26 Quadra-Fire · Castile Gas Stove · 7023-111E July 29, 2008