2Getting Started
A. Design & Installation Considerations
CAUTION
Check building codes prior to installation.
•Installation MUST comply with local, regional, state and national codes and regulations.
•Consult local building, fire officials or authorities having jurisdiction about restrictions, installation inspection, and permits.
When planning an installation, it is necessary to determine the following information before installing:
•Where the appliance is to be installed.
•The vent system confi guration to be used.
•Gas supply piping.
•Electrical wiring.
•Whether optional accessories - devices such as a blower, thermostat or remote control - are desired.
C. Inspect Appliance & Components
WARNING
Inspect appliance and components for damage. Damaged parts may impair safe operation.
•Do NOT install damaged components.
•Do NOT install incomplete components.
•Do NOT install substitute components.
Report damaged parts to dealer.
•Carefully remove the appliance and components from the packaging.
•Remove cast door and glass door, and set aside on pro- tective surface.
•Remove log set and component pack from fi rebox.
•Report to your dealer any parts damaged in shipment, particularly the condition of the glass.
•Read all of the instructions before starting the instal- lation. Follow these instructions carefully during the installation to ensure maximum safety and bene t.
WARNING
Keep appliance dry.
•Mold or rust may cause odors.
•Water may damage controls.
B.Tools and Supplies Needed
Before beginning the installation be sure that the following tools and building supplies are available. Note: Not all
tools will apply to every installation.
Reciprocating saw | Variable Speed Drill/Driver |
Pliers | Wrench Set |
Hammer | Framing Square |
Phillips Screwdriver | Framing Material |
Flat Blade Screwdriver | Hi temp caulking material |
Plumb Line | Voltmeter |
Level | Gloves |
Manometer | Safety Glasses |
Tape Measure | |
| or combustible gas detector |
WARNING
Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:
•Installation and use of any damaged appliance or vent system component.
•Modifi cation of the appliance or vent system.
•Installation other than as instructed by Hearth & Home Technologies.
•Improper positioning of the gas logs or the glass door.
•Installation and/or use of any component part not approved by Hearth & Home Technologies.
Any such action may cause a re hazard.
Page 6 | July 29, 2008 |