2700-I ACC Wood Insert
R
C. Blower Replacement
1.Using a 5/32 Allen wrench, remove 4 blower housing mounting bolts and slide assembly out. Figure 22.1.
2.Disconnect the wires from the blower.
3.Using a Phillips head screw driver, remove 4 screws. Figure 22.2.
4.Remove blower from the blower housing assembly.
5.Install new blower and secure with the same 4 screws.
Caution
Shock Risk.
•Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appliance.
6.
7.Slide the assembly back into position under the ash lip and secure with the 4 mounting bolts.
Remove Bolts and Slide |
Blower Assembly Out |
Figure 22.1
WARNING
Fire Risk.
Do NOT allow hot coals or embers to overflow ash lip
•May melt protective wire coating on fan power cord causing electrical short, fire or injury
Remove 4 Screws & Remove Blower from Housing
Figure 22.2
Page 22 | December 15, 2009 |