R
E. Securing Appliance to Stove Pipe/Liner | F. Surround & Trim Kit Installation |
1.Once you have the appliance in place and secured, remove the tube channel assembly, baffle board and ceramic blanket. Detailed instructions are found on pages 23 and 24.
2.Reach up through the flue opening and grab the attach- ment bar and pull down inside flue opening. Figure 41.1.
3.Insert the 5/16 bolts inside the cast flue and through the chimney mounting bar. Securely tighten the nuts. Fas- teners are provided.
4.
1.Lay surround face down on a protected surface to pre- vent scratching.
2.Using a Phillips head screw driver attach the side sur- rounds to the top surround using (2) #8 sheet metal screws on each side provided with the kit. Figure 41.2.
3.Lay the trim face down and place the corner brackets into position.
4.Using a standard flat screw driver tighten the corner brackets. Figure 41.3.
5.Slide the assembled trim set over the surround set. and then over the appliace. Figure 41.4.
| 5/16 Bolts |
5/16 Nuts | Attachment Bar |
Figure 41.1
Secure 2 Side Surrounds to |
Top Surround |
Figure 41.2
Corner Brackets |
Figure 41.3
Slide |
|
|
Surround | and | |
Trim over |
| |
| Appliance |
|
| Figure 41.4 |
|
|
|
|
|
|
December 15, 2009 | Page 41 |