OmniTek 839-1340, 839-1290, 839-1320 owner manual Existing Masonry Chimney

4. Existing Masonry Chimney

Type A - Up & Out Installations for Top Vent Configurations

Type B - Hearth Rear Vent Installations for Use With Rear Vent Kit (see Section 12 for conversion kit and venting components.)

Termination Cap

Top AdaptorFlashing

	4 in. (102mm)
Retro Connector	Flex Liner
90° Elbow

Direct Vent Pipe

Co-Axial to

Co-Linear Connector

Pipe Length

Optional

Chimney Liner Termination Cap

3 in. (76mm)

Flex Liner

Figure 5.24

Co-Axial to

Co-Linear

Connector

Pipe Length

Optional

Chimney Liner

Termination Cap

30 ft. (9m) of 3 in. (76mm) Flex Liner Exhaust Section

This section of the chimney must be sealed

The chimney must be sealed from the 4 ft. (1m) section to termination using a smoke shelf or a damper.

The seal should be 6 in. (152mm) below the end of the 4 ft. (1m) Air Intake section.

4 ft. (1m) of 3 in.

(76mm) Flex Liner Air Intake Section

20 Quadra-Fire • Topaz • 7009-113 Rev. J • 12/11