OmniTek 839-1290, 839-1320, 839-1340 owner manual Accessories, Leg Leveling System

Page 30

Figure 8.6 Install vent pipe adapter with gasket or high-temp silicone to rear vent opening.

Figure 8.9 Slide assembled nuts and bolts into the slots on the legs with the nuts on the bottom.

Figure 8.10 Use a 5/32 in. 4mm) Allen wrench to adjust legs up and down to desired level.

Figure 8.7 Place grille gently into the opening on top of the appliance.

D. Accessories

Install approved accessories per instructions included with accessories. Refer to Section 12 for appropriate accesso- ries.

C. Leg Leveling System

Figure 8.8 Thread Allen bolts through nuts until flush. The Allen bolts and nuts are included in the component pack inside the appliance firebox.

WARNING

Shock or fire risk.

Use ONLY optional accessories approved for this appliance.

Using non-listed accessories voids warranty.

Using non-listed accessories may result in a safety hazard.

Only Hearth & Home Technologies approved accessories may be used safely.

30

Quadra-Fire • Topaz • 7009-113 Rev. J • 12/11

Image 30
Contents Do Discardnot Hot glass will cause burnsWelcome to the Quadra-Fire Family Table of Contents 1Listing and Code Approvals Gas Equipment Venting System Provided Requirements for the Commonwealth of MassachusettsManufacturer Requirements Gas Equipment Venting System not ProvidedInspect Appliance & Components Design & Installation ConsiderationsGetting Started Tools and Supplies NeededSelecting Appliance Location ClearancesDesign Purposes only 4Termination Locations Vent Termination Minimum ClearancesAlcove Applications Use of Elbows Vent InformationVenting Components Measuring StandardsVertical Distance How to Use the Vent GraphVenting Guidelines From Appliance toHorizontal Termination Type a Up & Out Installations for Top Vent ConfigurationsType B Rear Installations for Use with Rear Vent Kit StepTop Vent Touching the hot cap Vertical Termination Direct Vent PipeStep Ceiling Joists Framing 2 in mm Long Wood Screws Twist-lock the vent cap and seal Cathedral Ceiling Class a Metal Chimney Existing Masonry Chimney Fire Risk Explosion Risk Retro Connector Gas Information Fuel ConversionsConverting to LP Gas Valve Regulator Replacement Propane Natural GASGas Pressures PressureGas Connection Check for GAS LeaksStanding Pilot Ignition System Wiring Recommendation for WireConnecting to the Appliance Wire Size Max. LengthIgnitor Red 28 711mm Switch Red 28Thermocouple Gas Pilot Ignitor Thermopile ON/OFFAppliance Setup Remove Shipping MaterialsTop to Rear Vent Conversion Accessories Leg Leveling SystemFront Installation Fronts shipped attached to face Brick InstallationFor Both Quartet and Solitaire Fronts Positioning the Logs Qty DescriptionMineral Wool Glass Door Assembly Replacement Blower InstallationWhite For TOP or Rear Vent Installations Damper AdjustmentShutter Adjustment Make adjustmentOperating Instructions Before Lighting ApplianceControls For Your Safety Read Before Lighting Lighting ApplianceFrequently Asked Questions Initial Break-in ProcedureAfter Appliance is Lit Troubleshooting Symptom Possible Cause Corrective ActionBe Placed in this Opening Maintaining and Servicing Your Appliance After servicingMaintenance Tasks Inspect Necessary. USE Caution When CLEANING/HANDLING Ceramic BurnerAppliance Dimension Diagram Reference MaterialsVent Components Diagram Mm inner pipe 6-5/8 in mm outer pipeSimpson Vent Components ListDescription Dura-VentDescription Dura-Vent HHT SLPSimpson Termination Caps & KitsRD. Service Parts List Log Set Assembly Part number list on followingDirect Vent Gas Stove At Depot Service Parts ListStocked Description Comments Part NumberBRNR-TOPAZ SIDE-TPZ-MBKSIDE-TPZ-POR TOUCHUP-CSB TOUCHUP-CWLStocked WSLG-CSB Description Comments Part Number AccessoriesBK-GAS FastenersLimited Lifetime Warranty Limited Lifetime WarrantyWarranty Conditions Topaz Contact InformationDealer Telephone