Monessen Hearth ILDV30NV, ILDV20NV, ILDV20PV manual Insert Placement, ILDV20 ILDV30

Page 10

ILDV20/ILDV30 Fireplace Insert

INSTALLATION

INSERT PLACEMENT

•The insert must be placed within a code-conforming masonry fireplace or a tested and listed zero-clearance (UL-127, solid fuel) fireplace. Repair any fireplace damage prior to installation.

•Because the insert uses a circulation blower, clean the fireplace, smoke shelf and chim- ney before installing.

•This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance produces when determining a location.

15Z\,"

18"

22Z\x"	28"
	14"
ILDV20	ILDV30

Figure 4

Minimum Openings

18"

21"

16"

10

83D0511

Image 10

Contents Ildv Series Direct Vent Gas Fireplace Insert What to do if YOU Smell GASVent Installation General Installation InformationInstallation Insert InstallationInstaller Important Safety InformationOwner Gas is commonly known as Never connect unit to privateNon-utility gas wells. This Wellhead gasProduct Specifications Product features and code approvalListed Vented GAS Fireplace Heater Before You Start High ElevationsOrifice SIZES, Pressures and BTUs ILDV20NV ILDV20PV ILDV30NV ILDV30PVInsert dimensions ILDV20 ILDV30General installation Information Insert ApplicationsMantel clearances ClearancesInsert Clearances Hearth RequirementsInsert Placement Installation ZERO-CLEARANCE Metal Fireplace RequirementsVent installation Installation PrecautionsVent Requirements Dealer or installer if you suspect an improperly adjusted Failure to adjust air shutter properly may lead to improperCombustion which can create a safety hazard. Consult your Altitude ConsiderationsVent Configurations Manifold Removal and Installation Remove Manifold and Attach to Flex VentInsert Installation Check gas typeUse pipe joint sealant that is resistant Insert installationTo liquid petroleum LP gas Do not use open flame to Check GAS PressureCheck for gas leaks Remote Wall mounted Switch Hand Held Remote ControlInstalling Logs and Rock Wool Ember Material in Firebox Log placementDo not use the entire bag of rock wool to cover burner area Place Log #6 Place Log #5 Surround installation Install SurroundInitial lighting Operating InstructionsWhat to do if YOU Smell GAS Never use an open flame to check for gas leakApproved leak testing method Lighting pilotLighting the burner Main burner switchPilot position Adjust the AIR Shutter Glass Frame Removal Glass Frame RemovalBlower Replacement Blower Parts List 20ILDV 30ILDVCleaning and Maintenance Cleaning glassRelight pilot. Refer to Maintenance Replacement Parts Replacement Parts Troubleshooting Observed Problem Possible Cause RemedyILDV20/ILDV30 Fireplace Insert Basic Warranty Lifetime WarrantyFive Year Warranty If Warranty Service is NeededMhsc AFUE%