Monessen Hearth ILDV30NV, ILDV20NV, ILDV20PV manual Vent Requirements

Page 13

vent installationILDV20/ILDV30 Fireplace Insert

VENT REQUIREMENTS

	WARNING	•	Make sure the exhaust pipe on heater connects to exhaust
		•	Make sure the exhaust pipe on heater connects to exhaust
			portion of cap. Attach flex liners. Figure 6
		•	Do not crimp or rupture liner when bending it into chimney
			offsets.

• The exhaust vent must reline the entire length of chimney and terminate above chimney top.

• Vent must meet all vent manufacturer's requirements when installed.

• Make sure you have the following before installing unit:

• 3" and 3" UL 1777 Listed gas liner for air inlet and exhaust.

• Vertical termination kit (AI31TK33A, HEDV32T812, HEDV32T1212, HEDVRT)

Figure 6

Venting Unit

Inlet

Exhaust

Maximum Height 40'

(12.9 m)

Minimum Height 10'

(3 m)

FP1922

83D0511

13

Image 13

Contents What to do if YOU Smell GAS Ildv Series Direct Vent Gas Fireplace InsertInstallation General Installation InformationVent Installation Insert InstallationInstaller Important Safety InformationOwner Non-utility gas wells. This Never connect unit to privateGas is commonly known as Wellhead gasProduct Specifications Product features and code approvalListed Vented GAS Fireplace Heater Orifice SIZES, Pressures and BTUs High ElevationsBefore You Start ILDV20NV ILDV20PV ILDV30NV ILDV30PVILDV20 ILDV30 Insert dimensionsInsert Applications General installation InformationInsert Clearances ClearancesMantel clearances Hearth RequirementsInsert Placement ZERO-CLEARANCE Metal Fireplace Requirements InstallationInstallation Precautions Vent installationVent Requirements Combustion which can create a safety hazard. Consult your Failure to adjust air shutter properly may lead to improperDealer or installer if you suspect an improperly adjusted Altitude ConsiderationsVent Configurations Remove Manifold and Attach to Flex Vent Manifold Removal and InstallationCheck gas type Insert InstallationUse pipe joint sealant that is resistant Insert installationTo liquid petroleum LP gas Do not use open flame to Check GAS PressureCheck for gas leaks Hand Held Remote Control Remote Wall mounted SwitchInstalling Logs and Rock Wool Ember Material in Firebox Log placementDo not use the entire bag of rock wool to cover burner area Place Log #6 Place Log #5 Install Surround Surround installationWhat to do if YOU Smell GAS Operating InstructionsInitial lighting Never use an open flame to check for gas leakLighting pilot Approved leak testing methodLighting the burner Main burner switchPilot position Adjust the AIR Shutter Glass Frame Removal Glass Frame RemovalBlower Replacement 20ILDV 30ILDV Blower Parts ListCleaning glass Cleaning and MaintenanceRelight pilot. Refer to Maintenance Replacement Parts Replacement Parts Observed Problem Possible Cause Remedy TroubleshootingILDV20/ILDV30 Fireplace Insert Five Year Warranty Lifetime WarrantyBasic Warranty If Warranty Service is NeededAFUE% Mhsc