Monessen Hearth ILDV30NV Never connect unit to private, Non-utility gas wells. This, Wellhead gas

ILDV20/ILDV30 Fireplace Insert IMPORTANT SAFETY INFORMATION

Continued from page 3

14.Do not use any solid fuels (wood, coal, paper, card- board, etc.) in this fireplace. Use only the gas type indicated on rating plate.

15.This appliance, when installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.

16.Do not obstruct the flow of combustion and ventilation air in any way. Provide adequate clearances around air openings into the combustion chamber along with adequate accessibility clearance for servicing and proper operation.

17.When the appliance is installed directly on carpeting, tile or other combustible material other than wood floor- ing, you must set appliance on a metal or wood panel or hearth pad extending the full width and depth of the appliance.

18.Do not use fireplace if any part has been exposed to or has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control which as been submerged in water.

19.Do not operate fireplace if any log is broken.

20.Do not use a blower insert, heat exchanger insert, or any other accessory not approved for use with this fireplace.

21.Do not operate the fireplace with glass door removed, cracked, or broken.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY It is normal for fireplaces fabricated of steel

to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.

IMPORTANT:

PLEASE READ THE FOLLOWING CAREFULLY

It is not unusual for gas fireplaces to give off some odor the first time it is burned. This is due to the manufacturing process.

Please ensure that your room is well ventilated during burn off — open all windows.

It is recommended that you burn your fireplace for at least ten (10) hours the first time you use it. Place the fan switch in the “OFF” position during this time.

WARNING	Never connect unit to private
	(non-utility) gas wells. This
	gas is commonly known as
	wellhead gas.

83D0511