Monessen Hearth ILDV30NV manual Check GAS Pressure, Do not use open flame to, Check for gas leaks

Page 19

CHECK GAS PRESSURE

ILDV20/ILDV30 Fireplace Insert

1.Check gas type. The gas supply must be the same as stated on the appliance’s rating decal. If the gas supply is different from the fireplace, STOP! Do not install the appliance. Contact your dealer immediately.

2.Install and attach flex line provided with on this appliance to 1/2" gas line.

3.After completing gas line connection, purge air from gas line and test all gas joints from the gas meter to the fireplace for leaks. Use a soap and water solution or a gas sniffer.

4.To adjust flame height, turn HI/LO knob to HI to get maximum pressure to burner. Turn HI/LO knob to LO to get minimum pressure.

5.To check gas pressures at valve, turn captured screw counter clockwise 2 or 3 turns and then place tubing to pressure gauge over test point. Turn unit to high. Figure 14. After taking pressure reading, be sure and turn captured screw clock- wise firmly to reseal. Do not over torque. Check test points for gas leaks with a soap and water solution or an electronic gas leak detector.

	WARNING	Do not use open flame to
		Do not use open flame to
		check for gas leaks.

Pressure

Test "IN"

Pressure Test "OUT"

HI/LO Knob	Pilot Adjustment Screw

Figure 14

Gas Pressure Check at Gas Valve

FP1932

83D0511

19

Image 19

Contents What to do if YOU Smell GAS Ildv Series Direct Vent Gas Fireplace InsertInsert Installation General Installation InformationInstallation Vent InstallationInstaller Important Safety InformationOwner Wellhead gas Never connect unit to privateNon-utility gas wells. This Gas is commonly known asProduct Specifications Product features and code approvalListed Vented GAS Fireplace Heater ILDV20NV ILDV20PV ILDV30NV ILDV30PV High ElevationsOrifice SIZES, Pressures and BTUs Before You StartILDV20 ILDV30 Insert dimensionsInsert Applications General installation InformationHearth Requirements ClearancesInsert Clearances Mantel clearancesInsert Placement ZERO-CLEARANCE Metal Fireplace Requirements InstallationInstallation Precautions Vent installationVent Requirements Altitude Considerations Failure to adjust air shutter properly may lead to improperCombustion which can create a safety hazard. Consult your Dealer or installer if you suspect an improperly adjustedVent Configurations Remove Manifold and Attach to Flex Vent Manifold Removal and InstallationCheck gas type Insert InstallationUse pipe joint sealant that is resistant Insert installationTo liquid petroleum LP gas Do not use open flame to Check GAS PressureCheck for gas leaks Hand Held Remote Control Remote Wall mounted SwitchInstalling Logs and Rock Wool Ember Material in Firebox Log placementDo not use the entire bag of rock wool to cover burner area Place Log #6 Place Log #5 Install Surround Surround installationNever use an open flame to check for gas leak Operating InstructionsWhat to do if YOU Smell GAS Initial lightingLighting pilot Approved leak testing methodLighting the burner Main burner switchPilot position Adjust the AIR Shutter Glass Frame Removal Glass Frame RemovalBlower Replacement 20ILDV 30ILDV Blower Parts ListCleaning glass Cleaning and MaintenanceRelight pilot. Refer to Maintenance Replacement Parts Replacement Parts Observed Problem Possible Cause Remedy TroubleshootingILDV20/ILDV30 Fireplace Insert If Warranty Service is Needed Lifetime WarrantyFive Year Warranty Basic WarrantyAFUE% Mhsc