Monessen Hearth ILDV30NV, ILDV20NV, ILDV20PV manual Manifold Removal and Installation

ILDV20/ILDV30 Fireplace Insert vent installation

MANIFOLD REMOVAL AND INSTALLATION

The manifold is shipped attached to insert. It may be removed to allow tight installation.

1.Remove glass door assembly following instructions on Page 29, Figure 34.

2.Lightly tap on flange of exhaust baffle assembly towards you until disengaged. Remove baffle, manifold and gasket from unit. Figure 10

3.ILDV20: Attach the solid closed baffle plate. ILDV30: Attach the slotted baffle plate. Figure 11

4.Feed exhaust flex through hole on top of insert and attach to manifold with hose clamp (not provided) or other approved methods (check local codes). Insure the gasket is in place before securing the flex to the manifold.

5.Re-attach exhaust baffle and manifold assembly in reverse order of Step 2.

6.Re-attach glass door in reverse order.

NOTE: Insert has an adjustable baffle and may be adjusted as needed by loosening four (4) screws. Figure 11

	Gasket		Flex Vent
			Manifold
			Baffle Assembly
Front View		Side View	FP1960

Figure 10

Remove Manifold and Attach to Flex Vent

Baffle Plate	Loosen Four (4)
(For ILDV20)	Screws to Adjust

Baffle

Assembly

FP2156
		Closed Baffle Plate
				Bottom View		Bottom View
Baffle Assembly
		Must use on ILDV20		Closed Position		Open Position
	ILDV20				ILDV30
					Baffle Plate
	Baffle Plate
NOTE: Make sure the correct			Figure 11
baffle plate is used.			Baffle Assembly and Adjustment

FP1961

16 83D0511