Monessen Hearth ILDV20PV, ILDV20NV, ILDV30NV Remote Wall mounted Switch, Hand Held Remote Control

ILDV20/ILDV30 Fireplace Insert ELECTRICAL INSTALLATION

Electrical Wiring

This insert will work without any electrical supply. Electricity is only needed to operate blower.

WARNING

Electrical connections should only be performed by a qualified, licensed electrician. Main power must be off when connecting to main electrical power supply or performing service. All wiring shall be in compliance with all local, city and state codes. The appli- ance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code ANSI/NFPA 70 (latest edition) and Canadian Electrical Code, CSA C22.1.

CAUTION

Label all wires before disconnecting when servicing controls. Wiring errors can cause improper and dangerous operation.

Verify proper operation after servicing.

Remote Wall mounted Switch

A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. At- tach the wall switch in a junction box at the desired location on the wall. Figure 15.

NOTE: Extended lengths of wire may cause the fireplace not to function properly. Longer length of wire is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local code.

Sparker			Thermopile
Thermocouple
			Pilot Assembly
Piezo Igniter			Switch
			ON	OFF
PILOT	HI
OFF	ON	TH
		TP
		TH/TP

Optional 15'

Wall Switch

ON

OFF

Millivolt

Valve

	Optional
	Remote Control
	ON
		Remote
Figure 15	OFF	Receiver
Wiring Diagram for Wall Switch

HAND HELD REMOTE CONTROL

The remote control receiver may be installed in the control panel by removing the ON/OFF switch and the knock-out plate. Slide the receiver into the space where the knock-out plate was removed. Refer to remote instructions for wiring and operation.

Figure 15a Remote Receiver

FP2177

20 83D0511