installation | ILDV20/ILDV30 Fireplace Insert |
ZERO-CLEARANCE (METAL) FIREPLACE REQUIREMENTS
•The damper and grate must be removed.
•The smoke shelf, internal baffles, screen, refractory and metal or glass doors may be removed (if applicable).
•Do not remove or alter the insulation or any structured rigid frame members (metal sides, floor, door frames, face of the fireplace, etc.).
WARNING
•Installer must attach red warning plate to the inside of the firebox of fireplace with screws supplied.
•Do not cut any sheet metal parts of the fireplace in which this gas fireplace insert is installed. THIS IS STRICTLY PROHIBITED!
•If
mm)or less through lower sides or bottom of firebox. You must plug the access hole with noncombustible insulation after gas supply line has been installed.
•If your
DO NOT BLOCK THESE PASSAGES!
|
| Insulation |
|
| |
|
| Smoke | Shelf | Damper |
|
|
|
|
| ||
|
|
|
|
| |
Doors |
| Masonry Lining or Refractory |
| Internal | |
|
|
|
| ||
Metal or Glass |
|
|
|
| Baffles |
Screen |
| Grate |
|
| |
|
|
|
| ||
|
| Masonry Lining or Refractory |
| ||
Figure 5
Metal Fireplace Zero-Clearance Requirements
IMPORTANT: Please review the following carefully.
It is normal for inserts fabricated of steel to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
It is not unusual for your insert to give off some odor the first time it is burned. This is due to the curing of the paint and any undetected oil from the manufacturing process.
Please ensure that your room is well ventilated. OPEN ALL WINDOWS DURING INITIAL BURN OFF/CURING PHASE.
Burn your insert for at least six (6) hours on "HIGH" the first time you use it. Place the fan in the "OFF" position during this time.
83D0511 | 11 |