ILDV20/ILDV30 Fireplace Insert | BLOWER REMOVAL and ASSEMBLY |
BLOWER REPLACEMENT
Turn off the unit and allow to cool completely. Turn off gas at
1.Remove the decorative filigree by gently pulling it out.
2.Rotate the cam on the glass toward the center.
3.Tilt the glass out left and release it from the track.
4.Set the glass on a towel out of the way.
5.Remove the logs and bricks. To remove the brick, unfasten the brackets located on the right and left.
6.Unfasten the brick support plate fastened to the burner.
7.Unfasten the rectangular plate located at the rear of the firebox by only removing the six
(6) screws around the perimeter of the plate.
8.Lift the plate up and slide to the left. You may have to rotate the plate to clear the blower through the hole.
9.Disconnect the two (2) wires to free the blower.
10.Reassemble the blower in reverse order.
Brick Retainers
Brick Panels
Blower Assembly
FP1963
Glass Door Assem- bly
Figure 35
Blower Removal and Assembly
30 | 83D0511 |