Monessen Hearth ILDV20NV Log placement, Installing Logs and Rock Wool Ember Material in Firebox

Page 21

log placement

ILDV20/ILDV30 Fireplace Insert

Before you begin - This unit is supplied with six (6) ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling the logs, wash your hands gently with soap and water to remove any traces of fibers.

WARNING

The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly posi- tioned in the appliance. Never add additional logs or embellishments such as pine cones or vermiculite to the heater. Only use the logs supplied with the unit.

Failure to position the parts in accordance with diagrams below or to use only parts specifically approved for this heater may result in property damage or personal in- jury.

INSTALLING LOGS AND ROCK WOOL (EMBER MATERIAL) IN FIREBOX

1.Break up rock wool (ember material) into dime-sized pieces. Place evenly as shown. Do not exceed 1" layer covering all round burner ports. Refer to Figures 16a and 16b.

2.Do not cover rectangular slots located at rear of burner.

Ember Material Area

WARNING

Do not use the entire bag of rock wool to cover burner area.

Figure 16a

Ember Material Area

FP1968

Figure 16b

Place Ember Material

LG536

Ember Material

83D0511

21

Image 21

Contents What to do if YOU Smell GAS Ildv Series Direct Vent Gas Fireplace InsertInstallation General Installation InformationVent Installation Insert InstallationImportant Safety Information InstallerOwner Non-utility gas wells. This Never connect unit to privateGas is commonly known as Wellhead gasProduct features and code approval Product SpecificationsListed Vented GAS Fireplace Heater Orifice SIZES, Pressures and BTUs High ElevationsBefore You Start ILDV20NV ILDV20PV ILDV30NV ILDV30PVILDV20 ILDV30 Insert dimensionsInsert Applications General installation InformationInsert Clearances ClearancesMantel clearances Hearth RequirementsInsert Placement ZERO-CLEARANCE Metal Fireplace Requirements InstallationInstallation Precautions Vent installationVent Requirements Combustion which can create a safety hazard. Consult your Failure to adjust air shutter properly may lead to improperDealer or installer if you suspect an improperly adjusted Altitude ConsiderationsVent Configurations Remove Manifold and Attach to Flex Vent Manifold Removal and InstallationCheck gas type Insert InstallationInsert installation Use pipe joint sealant that is resistantTo liquid petroleum LP gas Check GAS Pressure Do not use open flame toCheck for gas leaks Hand Held Remote Control Remote Wall mounted SwitchLog placement Installing Logs and Rock Wool Ember Material in FireboxDo not use the entire bag of rock wool to cover burner area Place Log #6 Place Log #5 Install Surround Surround installationWhat to do if YOU Smell GAS Operating InstructionsInitial lighting Never use an open flame to check for gas leakLighting pilot Approved leak testing methodMain burner switch Lighting the burnerPilot position Adjust the AIR Shutter Glass Frame Removal Glass Frame RemovalBlower Replacement 20ILDV 30ILDV Blower Parts ListCleaning glass Cleaning and MaintenanceRelight pilot. Refer to Maintenance Replacement Parts Replacement Parts Observed Problem Possible Cause Remedy TroubleshootingILDV20/ILDV30 Fireplace Insert Five Year Warranty Lifetime WarrantyBasic Warranty If Warranty Service is NeededAFUE% Mhsc