31
5.7.2 INSTALLING "B" VENT
Follow the instructions of the "B" vent manufacturer for chim- ney installation.
A.Remove the access plate. Remove and discard the air intake cover plate located directly behind the ac- cess plate.
B.Feed the 2 wires, supplied, through the 7" collar at the top of the unit, bring them out the air intake opening but behind the rear panel as shown.
NOTE: Ensure that 2 female ends remain at the top.
ACCESS PLATE LOCATION 
C. | Remove the spill switch bracket from the rear of the | FIGURE 5.7.2a |
| adapter. Unscrew the spill switch and discard the |
|
| bracket. Attach the spill switch to the bracket supplied |
|
| with the appliance and secure onto the adapter. | AIR INTAKE COVER |
|
| |
D. | Bring the wires through the lower hole in the adapter. | PLATE LOCATION |
| ||
| To pass the wires through the hole more easily, tem- |
|
| porarily tape the two terminals together. | FIGURE 5.7.2g |
|
| |
E. | With the spill switch opening aligned to the back of the ap- | ADAPTER |
| pliance, take hold of the adapter base and push the crimped | |
| edge into the appliance flue collar. | SPILL |
|
| |
F. | Connect the upper wire terminals to the spill switch. | SWITCH |
G. | Disconnect the wire leads to on/off switch, see "WIRING |
|
| DIAGRAM" section and reconnect to the ends of the spill |
|
| switch wires. Leave all excess wire in an orderly manner. |
|
For aesthetics, the adapter has been designed to accept a standard matte black 7" appliance pipe and the Napoleon® decorative brass band (standard with the
5.7.3 B-VENT
Attach the
ATTACH THIS LABEL IN THE CONTROL AREA OF THE FIREPLACE.
THIS FIREPLACE HAS BEEN CONVERTED TO A ‘B’VENT MODEL.
ATTACHEZ CET ETIQUETTE DANS LA REGION DE CONTROLE DU FOYER.
CEFOYERAETECONVERTIAUNMODELEASYSTEMED’EVACUATION‘B’.
5.7.4 COMBUSTION AIR
This appliance needs air for safe operation and must be installed in such a way that adequate combustion air is available.