36
6
7
Position the notch located in log #6 against the grate post.
Place the bottom of log #7 against the right outermost grate post and the top into the pocket provided on the center log (#6). Bend up the tab in the log support to cradle log #7. Tear the glowing embers into pieces and place onto the front of the burner. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fibre hairs will glow when exposed to direct flame; however care should be taken to not block the burner ports. Blocked ports can cause an incorrect flame pattern, carbon deposits and delayed ignition.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour pigments burn in during the heat activated cur- ing process.
POSITIONING THE LOGS IMPROPERLY WILL
CAUSE FLAME IMPINGEMENT AND
CARBONING.
6.5LOGO PLACEMENT
Remove the backing of the logo supplied and centre over the logo installation holes, as indicated.
FIGURE 6.5