Napoleon Fireplaces GDS60N manual Wiring Diagram

39

8.0 WIRING DIAGRAM

This appliance comes equipped with a battery back-up. If this backup is used install four AA batteries (not supplied) into the holder and connect to the wire harness. Place near the IPI board. Connect the battery holder to the wire harness before using the appliance. Place near the IPI board. (Batteries not included). If backup is used, it must be connected to the 6 volt battery pack supplied.

			ACS/IPI
		FIGURE 8.0	SWITCH
			ON / OFF	GREEN
			SWITCH	ORANGE
DC BACK-UP
+	-
		TRANSFORMER		IPI / CPI
-	+		ON / OFF
			DISCONNECT THESE	VALVE
			CONNECTORS TO THE
				ELECTRONIC
			ON/OFF SWITCH AND
			CONNECT TO
			OPTIONAL WALL /	VALVE
			THERMOSTAT SWITCH	IPI BOARD
			AND / OR SPILL SWITCH
			TO “B” VENT ADAPTOR
				GROUND
				EYELET
				GROUND
				DFC
		DC SUPPLY

W415-0788 / A / 09.22.09