TROUBLESHOOTING
Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle).
WARNING! | In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the electrical |
breaker, and consult authorized service personnel. | |
| Merely turning off the unit’s power switch will not completely disconnect the unit from the power |
| source. Always be sure to turn off the electrical breaker to ensure that power is completely off. |
Before requesting service, perform the following checks:
| Symptom |
|
| Problem | See |
|
|
| Page | ||
|
|
|
|
| |
NORMAL | Doesn’t operate immedi- | ● If the unit is stopped and then immediately started again, the com- |
| ||
FUNCTION | ately: |
| pressor will not operate for about 3 minutes, in order to prevent |
| |
|
|
| fuse blowouts. | — | |
|
| ● Whenever the electrical breaker is turned off then on again, the | |||
|
|
| |||
|
|
| protection circuit will operate for about 3 minutes, preventing unit |
| |
|
|
| operation during that period. |
| |
| Noise is heard: | ● During operation and immediately after stopping the unit, the |
| ||
|
|
| sound of water flowing in the air conditioner’s piping may be heard. |
| |
|
|
| Also, noise may be particularly noticeable for about 2 to 3 minutes | — | |
|
|
| after starting operation (sound of coolant flowing). | ||
|
| ● During operation, a slight squeaking sound may be heard. This is |
| ||
|
|
| the result of minute expansion and contraction of the front panel |
| |
|
|
| due to temperature changes. |
| |
|
| *● | During Heating operation, a sizzling sound may be heard occasion- | 14 | |
|
|
| ally. This sound is produced by the Automatic Defrosting operation | ||
|
|
|
| ||
| Smells: | ● Some smell may be emitted from the indoor unit. This smell is the |
| ||
|
|
| result of room smells (furniture, tobacco, etc.) which have been | — | |
|
|
| taken into the indoor unit. |
| |
| Mist or steam are | ● During Cooling or Dry operation, a thin mist may be seen emit- |
| ||
| emitted: |
| ted from the indoor unit. This results from the sudden Cooling of | — | |
|
|
| room air by the air emitted from the indoor unit, resulting in con- | ||
|
|
|
| ||
|
|
| densation and misting. |
| |
|
| *● During Heating operation, the outdoor unit’s fan may stop, and |
| ||
|
|
| steam may be seen rising from the unit. This is due to the Auto- | 14 | |
|
|
| matic Defrosting operation. |
| |
| Airflow is weak or stops: | *● When Heating operation is started, fan speed is temporarily very |
| ||
|
|
| low, to allow internal parts to warm up. |
| |
|
| *● | During Heating operation, if the room temperature rises above | — | |
|
|
| the thermostat setting, the outdoor unit will stop, and the indoor | ||
|
|
|
| ||
|
|
| unit will operate at very low fan speed. If you wish to warm the |
| |
|
|
| room further, set the thermostat to a higher setting. |
| |
|
| *● During Heating operation, the unit will temporarily stop opera- |
| ||
|
|
| tion (between 4 and 15 minutes) as the Automatic Defrosting | 14 | |
|
|
| mode operates. During the Automatic Defrosting operation, | ||
|
|
|
| ||
|
|
|
| will be shown on the remote controller display. |
|
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|
|
|
| ● | The fan may operate at very low speed during Dry operation or | — | |
|
|
| when the unit is monitoring the room’s temperature. | ||
|
|
|
| ||
|
| ● | During QUIET operation, the fan will operate at very low | — | |
|
|
| speed. | ||
|
|
|
| ||
|
| ● | In the monitor AUTO operation, the fan will operate at very low | — | |
|
|
| speed. | ||
|
|
|
|
●In case of
| ward will stop and the OPERATION indicator lamp (green) will | 16 | |||
| flash, |
| will be shown on the remote controller display. | ||
|
|
| |||
|
|
| |||
| Heating mode and cooling mode (or dry mode) |
| |||
| Heating mode and fan mode |
| |||
Water is produced from | *● During Heating operation, water may be produced from the out- | 14 | |||
the outdoor unit: | door unit due to the Automatic Defrosting operation. | ||||
| |||||
The ECONOMY Indicator flashes | ● Clean the filter. Afterwards, turn the ECONOMY Indicator off. | 12 | |||
thermo sensor display | ● The room temperature sensor may be malfunctioning. Please con- |
| |||
on the remote controller | sult authorized service personnel. | — | |||
is flashing: |
|
|
|
|
9/6/2010 10:36:32 AM