Bosch Appliances DS7400XIV4-EXP manual Custom Arming

DS7400XiV4-EXP User Guide 6.0 Day to Day Operations

EN 10

6.1.4Custom Arming

Custom arming is used to arm zones that you specify and your installer programs into your system. An entry/exit delay is in effect unless otherwise programmed.

The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section 6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).

Table 6: Custom Arming

Equipment	Command Sequence	What Happens	What To Do
Text Keypad LED	[PIN][#][4]	• The red Armed LED flashes.	Exit during the exit-delay
Keypad		• “On Partial” is displayed. *	period.
		• “Exit Now” is displayed during the exit-
		delay period. *
		• The green Status LED lights steady.
		• A single beep sounds.
		• The red Armed LED lights steady when
		the exit-delay period ends.
		• The zones that were programmed for
		custom arming are armed.
RF3341 Keypad	[PIN][#][4]	• The LED flashes indicating a signal was	Exit during the exit-delay
		sent to your security system.	period.
		• The zones programmed for custom
		arming are armed.
RF3332/RF3332E,		Not applicable
RF3334/RF3334E
* Text Keypad only

Bosch Security Systems 6/05 4998154961B