Testing Your System | |
|
|
EN 28
10.2Battery Tests
If a power failure occurs, your control panel has a backup battery that continues to power the control panel for many hours. The control panel automatically recharges the battery when power is restored.
In addition to the automatic battery test performed every 2 minutes, you can also test the battery manually. This test also uses the battery to manually activate all the system sounders for 2 seconds ([PIN][#][8][5] only). If the battery voltage is low, a battery fault occurs (refer to Section 9.0 Error Displays on page 25).
If you perform this test from a Master keypad, the keypad must be in Single Partition Mode. System Tests are not available from RF (wireless) keypads.
Table 26: Zone Test
|
|
|
|
Type of Test | Command Sequence | What Happens | What To Do |
|
|
|
|
Local Battery/ | [PIN][#][8][5] | • All keypad LEDs turn on. | • If the sounder fails to operate |
Sounder Test |
| • The keypad sounder and all alarm | or if the battery fails, contact |
|
| sounding devices operate for 2 seconds. | your installing company. |
|
| • If the test fails, the control panel indicates |
|
|
| a control problem. Refer to Section 9.0 |
|
|
| Error Displays on page 25. |
|
Battery Test | [PIN][System Reset] | • The control panel performs a battery test. | • Contact your installing |
|
| • The control panel reports a Low Battery | company if a low or missing |
|
| or a Low Battery Restoral is necessary. | battery is reported. |
10.3Communicator Test
This test is available only if your system sends alarms and system information to a monitoring service, and is programmed by the installing company to permit communicator tests. You can perform this test from a Master Keypad. The account code for Area #1 is used. System tests are not available from RF (wireless) keypads.
A long beep initially sounds to acknowledge the start of the test. If the test is successful, the sounder again sounds one long beep. If the test fails, the keypad sounder turns ON continuously. To silence the sounder, enter your [PIN] and press the [#] key or the [*] key.
Table 27: Communicator Test
|
|
|
|
Type of Test | Command Sequence | What Happens | What To Do |
|
|
|
|
Communicator | [PIN][#][8][2] | • A long beep sounds. | To silence the sounder, press |
Test |
| • A “Test” report is sent to the monitoring | [System Reset]. |
|
| service. | Note: This test can take several |
|
| • If the test fails, the keypad sounder | minutes to complete because the |
|
| operates continuously. | control panel attempts ten calls. |
|
|
|
|
Bosch Security Systems 6/05 4998154961B