Bosch Appliances DS7400XIV4-EXP manual Day to Day Operations, Standard Operations, Normal Arming

DS7400XiV4-EXP User Guide 6.0 Day to Day Operations

EN 7

6.0Day to Day Operations

6.1Standard Operations

This section describes the standard (those built and programmed into your system at the factory) procedures for arming and disarming your security system. Your installing company can program your system for various optional operations (refer to Section 6.2 Optional Operations).

6.1.1Normal Arming

Normal arming is used when no one is left on the premises, all zones must be armed, and an entry/exit delay is in effect. The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section 6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).

Table 3: Normal Arming

Equipment	Command Sequence	What Happens	What To Do
Text Keypad	[PIN][On]	• The red Armed LED flashes.	Exit during the exit-delay period.
LED		• “Armed” is displayed. *
Keypad		• “Exit Now” is displayed during the exit-delay
		period. *
		• A single beep sounds.
		• The red Armed LED lights steady when the
		exit-delay period ends.
		• All zones are armed.
RF3341	[PIN][#][1]	• The LED flashes indicating a signal was	Exit during the exit-delay period.
Keypad		sent to your security system.
		• All zones are armed.
RF3332	Press ARM button	All zones are armed.	Exit during the exit-delay period.
RF3334
* Text Keypad only

Bosch Security Systems 6/05 4998154961B