Bosch Appliances DS7400XIV4-EXP manual Maximum Security Arming

DS7400XiV4-EXP User Guide 6.0 Day to Day Operations

EN 11

6.1.5Maximum Security Arming

Maximum security arming is used when no one is still in the building, all zones are to be armed, an exit delay is in effect, but no entry delay is in effect so an alarm does occur upon entry.

The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section 6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).

Table 7: Maximum Security Arming

Equipment	Command Sequence	What Happens	What To Do
Text Keypad LED	[PIN][No Entry][On]	• The red Armed LED flashes.	•	Exit during the exit-delay
Keypad		• “Armed Instant” is displayed. *		period.
		• “Exit Now” is displayed during the exit-	•	Violating any zone after the
		delay period. *		exit-delay period ends
		• A single beep sounds.		triggers an instant alarm.
		• The red Armed LED lights steady when
		the exit-delay period ends.
		• All zones are armed.
RF3341 Keypad	[PIN][#][5]	• The LED flashes indicating a signal was	•	Exit during the exit-delay
		sent to your security system.		period.
		• All zones are armed.	•	Violating any zone after the
				exit-delay period ends
				triggers an instant alarm.
RF3332/RF3332E,		Not applicable
RF3334/RF3334E
* Text Keypad only

Bosch Security Systems 6/05 4998154961B