Bosch Appliances D9412GV3, D7412GV3 Telephone Connections, Registration, Notification, Location

D9412GV3/D7412GV3 Operation and Installation Guide 7.0 Telephone Connections

7.0Telephone Connections

7.1Registration

The Bosch Security Systems, Inc. D9412GV3 and D7412GV3 Control Panels are registered with the Federal Communication Commission (FCC) under Part 68, for connection to the public telephone system using an RJ31X or RJ38X jack installed by the local telephone company.

An RJ31X jack can be modified by placing a jumper wire between Terminals 2 and 7 to become an RJ38X jack.

7.2Notification

Do not connect registered equipment to party lines or coin-operated telephones. Notify the local telephone company and provide the following information before connecting the control panel to the telephone network:

The particular line to which the control panel will be connected

Make (Bosch Security Systems, Inc.), model (D9412GV3 or D7412GV3), and serial number of the control panel

FCC registration number: US:ESVOT00BD9412GV3

Ringer equivalence for the control panel: 0.0B

7.3Location

To prevent jamming of signals, wire the RJ31X or RJ38X jack before the in-house telephone system to support line seizure (Figure 10). Install the jack on the street side of the telephone switch, wired ahead of any PBX equipment. Line seizure temporarily interrupts normal telephone usage while the control panel sends data. After installation, confirm that the control panel seizes the line, acquires dial tone, reports correctly to the receiver, and releases the telephone line to the in-house telephone system.

Figure 10: RJ31X Wiring

		RJ31X	1
RING (red)	TIP (green)
R1 R	T	T1

1	2	4	5	7 8
1		4	5	8

2	3			4
	1	4	5	8

5

6

1 - RJ31X Jack

2 - (TIP)

3 - (RING)

4 - Telco connector block

5 - Outside telco

6 - Premises telephone

7.4Telephone Cord Connection

Connect one end of a D161 (2.1 m [7 ft.]) or a D162 [61 cm (2 ft.)] Telephone Cord to the telco cord connector located on the bottom left corner of the control panel. Refer to Figure 11. Connect the other end to the RJ31X or RJ38X jack.

To supervise the phone cord, use an

RJ38X jack.

Figure 11: Phone Connector, Phone LED, and Operation Monitor LED Locations

1

PHO NE LINE SEIZED 2

PH ON E LIN E SEIZ ED LE D
O N w hen communicating
O FF w hen idle
TIP	R NI	G	11	12	13	14	15	1 6	17	18	19	2 0	21	22
RED TE LCO C OR D MOD EL D161

TIP RIN G

TELC O

Point 8, S3 Opti on	D5200/D5360
	PROG CONN

Open = AB-12 UL

Bel l Box 220 k

Operation Monit or LED

Pulses when Normal

Flick ers whe n Ringing

G REEN

3

1 -		Phone LED (red)	3 - Operation Monitor LED (green)
2 -		Telephone cord connector
	Bosch Security Systems, Inc. 10/10 F01U143070-03		28