Installation Instructions
ALL MODELS |
| ||
3°"DIA.VENT |
| NUMBER | OF 90 ° DEG. |
MAX. LENGTH | (FT.) | ELBOWS • | |
115 |
|
| I |
II0 |
|
| 2 |
105 |
|
| 3 |
100 |
|
| 4 |
95 |
|
| 5 |
9O |
|
| 6 |
ALL MODELS m THROUGH ROOF |
| ||
OPTIONAL 2" VENT PIPING |
|
| |
2" DIA.VENT |
| NUMBER | OF 90 ° DEG. |
MAX. LENGTH | {FT.) | ELBOWS • | |
| I | ||
5O |
|
| |
45 |
|
| 2 |
4O |
|
| 3 |
35 |
|
| 4 |
3O |
|
| 5 |
25 |
|
| 6 |
*NOTE: Two 45 ° elbows are equivalent to one 90 ° elbow. One 90 ° elbow equals 5 feet of equivalent vent length.
Gas Piping
_WARNING
Hake sure the gas supplied is the same type listed on
the model rating plate. The inlet gas pressure must not exceed 10.5 in. water column (2.6 kPa) for natu- ral gas or 13 in. water column (3.2 kPa) for Propane
(L.R) gas. The minimum inlet gas pressure listed on the model rating plate is for the purpose of input adjustment.
(cont'd)
A gas line of sufficient size must be run to the water heater. Consult the current edition of National Fuel Gas Code ANSI
Z223.1, also referred to as NFPA 54 and the gas company con- cerning pipe size.
There must be:
•A readily accessible manual shut off"valve in the gas supply line serving the water heater, and
•A drip leg (sediment trap) ahead of the gas control valve to
help prevent dirt and foreign materials from entering the gas control valve.
•A flexible gas connector or a ground joint union between the shutoffvalve and control valve to permit servicing of the unit.
Be sure to check all the gas piping for leaks before lighting the water heater. Use a soapy water solution, not a match or open flame. Rinse offsoapy solution and wipe dry.
Standard Models are for installation up to 3,300 feet above sea level.
High Altitude Models are for installation from 3,300 to 5,500 feet above sea level.
lfa standard model is installed above 3,300 feet or a high altitude model is installed above 5,500 feet, the input rating must be reduced at the rate of 4 percent for each 1,O00 feet above sea level which requires replacement of the burner orifice in accordance with the National Fuel Gas Code Z223.1, NFPA 54. Contact the
local Sears Service Center or your local gas utility for further information.
AWARNING
Failure to replace the standard orifice with a high
altitude orifice when installed at elevations above
3,300 feet (or above 5,500 feet for high altitude
model), could result in improper and inefficient operation of the appliance, producing carbon monox- ide gas in excess of safe limits, which could result in
serious injury or death. Contact the local Sears Service Center or your gas supplier for any specific changes which may be required in your area.
|
| AWARNING |
|
|
| I |
| |
If the gas control valve is subjected to pressures |
|
| ||||||
exceeding | ½ | pound per | square | inch | (3.5kPa), | the I | J | |
damage | to the gas control | valve | could | result in a | fire | AWARNING | ||
or expos | on | from eak ng gas. |
|
|
| The appliance and its gas connection must be | leak | |
|
|
|
|
|
|
| tested before placing the appliance in operation. |
|
AWARNING
If the main gas line shutoff serving all gas appliances is used, also turn "off" the gas at each appliance.
Leave all gas appliances shut off until the water heater installation is complete.
23