Operating Instructions (cont'd)
| explosion may result causing property damage, personal injury or |
|
| ||||||
_[,_WARNING:lfyoudonotfollowtheseinstructionsexactiy, |
| afireor_ |
|
| |||||
| loss | of life. |
|
|
|
|
|
|
|
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATERAND AIR PURGED FROM ALL LINES. | |||||||||
A. This appliance does not have a pilot. | It is equipped | • If you cannot | reach your gas supplier, | call the | fire | ||||
with an ignition device which automatically | lights the | department. |
|
|
| ||||
burner. Do NOT try to light the | burner by | hand. | C. Use only your | hand to push in the gas | control | but- | |||
B. BEFORE | OPERATING | smell | all | around the | tons. Never use tools. If the control buttons will not | ||||
appliance | area for gas. | Be sure to smell next to the | push in, don'ttry to repair them, call a qualified | ser- | |||||
floor because some gas is heavier than air and will | vice technician. | Force or | attempted | repair | may | |||||
settle on the floor. |
| result in a fire or | explosion. |
|
|
|
|
| ||
WHAT TO DO IF YOU SMELL GAS: | D. Do not use | this | appliance | if any | part | has | been | |||
Do not try to light any appliance. | under water. | Immediately | call a qualified | service | ||||||
Do not touch any electric switch; | technician to | inspect | the appliance | and to | replace | |||||
do not use any phone in your building. | any part of the control | system and | any gas | control | ||||||
Immediately call your | gas supplier from a neighbor's | which has been under | water. |
|
|
|
| |||
phone. Follow the gas | supplier's instructions. |
|
|
|
|
|
|
|
|
|
.......7 | • | A | IJ | Ovem |
WARUO O | O | O | O | O ,O |
......e | e | ...... | ||
i |
|
|
| i |
1. I_STOP! | Read the safety information above |
_,#'on | this label. |
2.Set the ON/OFF switch on the control box to the "ON" position.
3.Set the thermostat to_e lowest setting b_rst press- ing the COOLER _ and HOTTER _ buttons
together and holdi.J_ for 1 second. Then press the COOLER button £_) until the WARM indicator light
appears.
4.Set the ON/OFF switch on the control box to the "OFF" position.
1.Set thermostat,_to the lowest settin_ by first pressing the COOLER _ and HOTTER _ buttons together and holding for 1 second. Then press the COOLER button (_ until the WARM indicator light appears.
5.This appliance is equipped with a device which auto- matically lights the burner.
DO NOT TRY TO UGHT THE BURNER BY HAND.
6. Wait five (5) minutes | to | if_ | clear | out any gas. | |
If you then smell gas, |
| _ | STOP! | Follow "B" in | |
the safety | information | above on this label. If you | |||
don'tsmell | gas, go to the next step. |
| |||
7.Turn on all electrical power to the appliance.
8.Set the ON/OFF switch on the control box to the "ON" position.
9.Set the thermo_t to desired setl_ by first pressing the COOLER k_)and HOTTER t,_,'buttons together
and hol_g for 1 second. Then press the HOTTER button _.
10.WATER TEMPERATURE ADJUSTMENT • is approximately 120°E
_ | CAUTION: Hotter water | increases the risk | |
| of scald | injury. Consult | the instruction |
| manual | before changing | temperature. |
11, if the appliance will not operate, follow the instruc- tions "TO TURN OFF GAS TO APPLIANCE" and call your technician or gas supplier.
,_ WARNING:BEFORETURNPOWERSERVICINGOFFALLELECTRIC
2.Set the ON/OFF switch on the control box to the "OFF" position.
3.Turn off all electric power to the appliance if service is to be performed.
28