Directed Electronics SR6000 manual Sense wire shutting down the unit prematurely

Page 28

sense wire shutting down the unit prematurely.

In addition, you must connect a tan (+) shut-down input to the yellow wire on the relay satellite ribbon cable. This prevents the remote start system from activating if the key is left in the "run" position. If your remote start system only has one tan input, you must use diodes to isolate the ignition circuit from the brake switch input.

However, due to future manufacturer changes in vehicles, it is possible that this may not apply to all vehicles. In addition, color variations are possible from model to model; make sure to test the circuit carefully. Please call Ungo Technical Support if you need assistance in making this interface.

IMPORTANT! Once the interface is complete, attempt to remote start the vehicle with the door closed and the key in the ignition. The vehicle should not start. If it does, recheck the connec- tions.

General Motors trucks, sport utility vehicles and column shifting passenger vehicles:

Pre-1996 Dodge Dakota pickups with 2.5 liter motors:

28

Image 28
Contents ProSecurity Page Table of contents Page Before beginning the installation Installation points to rememberAfter the installation Locations for the siren Locations for the control moduleLocations for stinger doubleguard shock sensor Locations for valet/program switch Locations for the status LEDFinding the wires you need Locations for the optional starter kill relayLocations for the relay satellite Obtaining constantFinding the 12V switched ignition wire Finding the starter wireFinding the tachometer wire Finding the accessory wireFinding the wait-to-start bulb wire for diesels Finding a + parking light wire Finding the door pin switch circuitMaking your wiring connections Auxiliary harness H2, 6-pin connector Door lock harness, 3-pin connector Heavy gauge relay satellite wiring diagram Primary harness H1 wire connection guide H1/3 WHITE/BLUE remote start activation input H1/5 Green door trigger input, zone H1/8 Black chassis ground connection Secondary harness H2 wire connection guide Page Relay key satellite interface wire connection guide Connect this wire to the ignition wire in the vehicle Remote start secondary harness H3 wire con- nection guide Neutral safety switch interface Figure aTesting the neutral safety switch Sense wire shutting down the unit prematurely Directed Electronics, Inc. Vista, CA Bypassing GM vehicle anti-theft systems Vats Passlock I and passlock II PL-1 and PL-2 Passkey III PK-3, transponder-based systemsPlug-in LED and valet/program switch Shock sensor harness, 4-pin connector Tach learning Programming jumpersTach threshold on/off Light flash +Function Wire Color Transmitter configurations Standard configurationMulti-level security arming PressingSystem features learn routine Tings. The sire will chirp once if connected. Pressing Feature menus Menu #1 basic featuresMenu #2 advanced features Menu #3 remote start optionsFeature descriptions Menu #2 advanced features Page Tion from 1-60 minutes Page Valet mode Nuisance prevention circuitryTimer mode Table of zonesTo perform shutdown diagnostics Shutdown diagnosticsLong term event history Safety check Troubleshooting Alarm troubleshootingRemote start troubleshooting Page Wiring quick reference guide Quick reference guide Get Started Get Protected