Directed Electronics SR6000 manual Shutdown diagnostics, Long term event history

shutdown diagnostics

to perform shutdown diagnostics

1.With the ignition OFF, press and HOLD the Valet/Program button.

2.Turn the ignition ON and then back OFF while HOLDING the Valet/Program button.

3.Release the Valet/Program button.

4.Press and release the Valet/Program button. The LED will report the last shutdown for one minute or until the ignition is turned on.

LED FLASHES	SHUTDOWN MODE
One	Timed out
Two	Over-rev shutdown
Three	Low or no RPM
Four	Transmitter shutdown (or optional push-button)
Six	(-) Shutdown (H3/3 GRAY) or (+) Shutdown (H3/4 BROWN)
Seven	(-) Neutral safety shutdown (H3/6 BLACK/WHITE)
Eight	Wait-to-start timed out

long term event history

The system stores the last two full triggers in memory. These are not erasable. Each time the unit sees a full trigger, the older of the two triggers in memory will be replaced by the new trigger. To access long term event history:

1. With the ignition off, press and HOLD the Valet®/Program switch.

2.Turn on the ignition.

50