Directed Electronics SR6000 manual Tings. The sire will chirp once if connected. Pressing

Page 40


5.	Transmit. The transmitter is used to select the desired setting. Pressing		will change
	the feature to the LED ON setting (or will flash once for features with more than 2 set-
	tings). The sire will chirp once (if connected). Pressing	will change the setting to the
	LED OFF setting (or will flash two or more times for features with more than 2 settings).

6. Release. The Valet®/Program switch can now be released.

You can advance from feature to feature by pressing and releasing the Valet®/Program switch the number of times necessary to get from the feature you just programmed to the feature you wish to access. For example, in Menu One, if you just programmed Feature 1-2 and you next want to program Feature 1-3 to off, release the Valet/Program switch. Press and release it once to advance from Feature 1-2 to Feature 1-3. Then press it once more and HOLD it. The LED will flash in groups of 3 and the horn will honk 3 times (if connected) to confirm that you have accessed Feature 1-3.

The learn routine will be exited if:

■The door is closed.

■The ignition is turned on.

■The Valet/Program switch is pressed too many times.

■More than 15 seconds elapses between programming steps.

One siren wail sound indicates that the Learn Routine has been exited.

40

Image 40

Contents ProSecurity Page Table of contents Page Before beginning the installation Installation points to rememberAfter the installation Locations for the siren Locations for the control moduleLocations for stinger doubleguard shock sensor Locations for valet/program switch Locations for the status LEDFinding the wires you need Locations for the optional starter kill relayLocations for the relay satellite Obtaining constantFinding the 12V switched ignition wire Finding the starter wireFinding the tachometer wire Finding the accessory wireFinding the wait-to-start bulb wire for diesels Finding a + parking light wire Finding the door pin switch circuitMaking your wiring connections Auxiliary harness H2, 6-pin connector Door lock harness, 3-pin connector Heavy gauge relay satellite wiring diagram Primary harness H1 wire connection guide H1/3 WHITE/BLUE remote start activation input H1/5 Green door trigger input, zone H1/8 Black chassis ground connection Secondary harness H2 wire connection guide Page Relay key satellite interface wire connection guide Connect this wire to the ignition wire in the vehicle Remote start secondary harness H3 wire con- nection guide Neutral safety switch interface Figure aTesting the neutral safety switch Sense wire shutting down the unit prematurely Directed Electronics, Inc. Vista, CA Bypassing GM vehicle anti-theft systems Vats Passlock I and passlock II PL-1 and PL-2 Passkey III PK-3, transponder-based systemsPlug-in LED and valet/program switch Shock sensor harness, 4-pin connector Tach learning Programming jumpersTach threshold on/off Light flash +Function Wire Color Transmitter configurations Standard configurationMulti-level security arming PressingSystem features learn routine Tings. The sire will chirp once if connected. Pressing Feature menus Menu #1 basic featuresMenu #2 advanced features Menu #3 remote start optionsFeature descriptions Menu #2 advanced features Page Tion from 1-60 minutes Page Valet mode Nuisance prevention circuitryTimer mode Table of zonesTo perform shutdown diagnostics Shutdown diagnosticsLong term event history Safety check Troubleshooting Alarm troubleshootingRemote start troubleshooting Page Wiring quick reference guide Quick reference guide Get Started Get Protected