Heat & Glo LifeStyle 6000TRS-CE Flue Termination, For Horizontal Terminations using the DVP-TRAP

Page 24

If the area above the ceiling is NOT an attic, position and secure the ceiling ﬁrestop on the ceiling side of the previously cut and framed hole.

JOIST

CEILING

NAILS (4 REQUIRED)

CEILING FIRESTOP

Figure 20. Ceiling Firestop (Ceiling Side)

If the area above the ceiling IS an attic, position and secure the ﬁrestop on top of the previously framed hole.

NAILS (4 REQUIRED)

RAFTER

	CEILING
	CEILING FIRESTOP

	Figure 21. Attic Firestop
	C. Flue Termination
CAUTION:	IF EXTERIOR WALLS ARE FINISHED WITH VINYL SID-
	ING, IT IS NECESSARY TO INSTALL THE VINYL PRO-
	TECTOR KIT (VPK-DV) TO THE TOP OF THE EXTERIOR
	FIRESTOP FOR ALL ROUND TERMINATION CAPS.
	For Horizontal Terminations using the DVP-TRAP
	To attach and secure the termination to the last section of
	horizontal ﬂue:
	• The rear ﬂue heat shield MUST be placed 2.54 cm above
	the top of the ﬂue between the wall shield and the base
	of the termination cap.
	• One section of the heat shield is attached to the wall
	shield. The other is attached to the termination cap in the
	same manner (see Figure 22).

24	Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/11

Image 24

Contents Model What to do if you smell gasSafety and Warning Information Installing the Fireplace Maintaining and ServicingLog Set Assembly Service PartsService Parts List 6000TRS-CEValve Assembly 6000TRS-CEInstallation Regulations Appliance CertiﬁcationANY Such Action MAY Possibly Cause a Fire Hazard Location Centimeters Step LocatingFireplace Clearance RequirementsStep Framing Fireplace Framing should be constructed of 2 X 4 lumber or heavierStep Installing Flue System Flue System ApprovalsIdentifying Flue Components DVP4 DVP6 DVP12 Straight UP Flue with ONE 1 90o Elbow Flue with TWO 2 90 Elbows Flue with TWO 2 90 Elbows Flue with Three 3 90 Elbows + H Installing Flue Components Venting Out the Rear FlueVenting Out the Top Flue Install Support Brackets On the TOP of the heaterInstall Firestops Installing Support BracketsFlue Pipe & Firestop For Horizontal Terminations using the DVP-TRAP Flue TerminationBe Positioned SO That the Arrow is Pointing UP DVP Termination Cap Outside of the building Alcove Applications Step Positioning Leveling, Securing Fireplace Standing Pilot Ignition SystemStep Gas Supply Line Optional Accessories Step Gas Pressure RequirementsFinishing Installing the Trim Installing the Ceramic ReFractory LOG Placement Heat & Glo 6000TRS-CE 2049-900 Rev. Q 2/11 Glass Assembly Placing the Ember MaterialReview safety warnings and cautions Double-check for faulty componentsStep Before Lighting Fireplace Double-check for gas leaksStep Lighting Fireplace After the Installation Maintaining Servicing Your Fireplace Make Sure the Flames Standing Pilot Troubleshooting With the pilot lit, and the ON/OFF switch Placed in this Opening Limited Lifetime Warranty Limited Lifetime WarrantyWarranty Conditions