Heat & Glo LifeStyle 6000TRS-CE manual Flue with ONE 1 90o Elbow

Page 15

V

H

Figure 9. Flue with One 90° Elbow

FLUE WITH ONE (1) 90o ELBOW

V	H
MIN. 30.5 cm	MAX. 61.0 cm
MIN. 61.0 cm	MAX. 1.22 m
MIN. 91.4 cm	MAX. 1.86 m
MIN. 1.22 m	MAX. 2.48 m
MAX. 7.3 m	MAX. 2.48 m

FLUE WITH ONE (1) 90o ELBOW

V	H
MIN. 30.5 cm	MAX. 1.22 m
MIN. 61.0 cm	MAX. 2.4 m
MIN. 91.4 cm	MAX. 3.7 m
MIN. 1.22 m	MAX. 4.9 m
V + H = MAX 7.3 m	H = MAX. 2.4 m

	H

V

NOTE: For corner installations: A 15.2 cm MINIMUM length of straight pipe must be ﬁrst attached to the ﬁreplace before 90o elbow. This will allow the ﬂue pipe to clear the top standoffs.

NOTE: If a 90º elbow is ﬁrst attached to the unit, the maximum horizontal run is 3 feet (91.4 cm).

Figure 10. Flue with One 90° Elbow

Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/11

15

Image 15

Contents What to do if you smell gas ModelSafety and Warning Information Maintaining and Servicing Installing the FireplaceService Parts Log Set Assembly6000TRS-CE Service Parts List6000TRS-CE Valve AssemblyAppliance Certiﬁcation Installation RegulationsANY Such Action MAY Possibly Cause a Fire Hazard Location Centimeters Clearance Requirements StepLocating FireplaceFraming should be constructed of 2 X 4 lumber or heavier Step Framing FireplaceStep Installing Flue System Flue System ApprovalsIdentifying Flue Components DVP4 DVP6 DVP12 Straight UP Flue with ONE 1 90o Elbow Flue with TWO 2 90 Elbows Flue with TWO 2 90 Elbows Flue with Three 3 90 Elbows + H Installing Flue Components Venting Out the Rear FlueVenting Out the Top Flue On the TOP of the heater Install Support BracketsInstalling Support Brackets Install FirestopsFlue Pipe & Firestop Flue Termination For Horizontal Terminations using the DVP-TRAPBe Positioned SO That the Arrow is Pointing UP DVP Termination Cap Outside of the building Alcove Applications Standing Pilot Ignition System Step Positioning Leveling, Securing FireplaceStep Gas Supply Line Step Gas Pressure Requirements Optional AccessoriesFinishing Installing the Trim Installing the Ceramic ReFractory LOG Placement Heat & Glo 6000TRS-CE 2049-900 Rev. Q 2/11 Placing the Ember Material Glass AssemblyDouble-check for gas leaks Review safety warnings and cautionsDouble-check for faulty components Step Before Lighting FireplaceStep Lighting Fireplace After the Installation Maintaining Servicing Your Fireplace Make Sure the Flames Standing Pilot Troubleshooting With the pilot lit, and the ON/OFF switch Placed in this Opening Limited Lifetime Warranty Limited Lifetime WarrantyWarranty Conditions