Heat & Glo LifeStyle 6000TRS-CE manual Appliance Certiﬁcation, Installation Regulations

Page 7

Appliance Certiﬁcation

The Heat & Glo ﬁreplace models discussed in this Installers Guide have been tested to certiﬁcation standards and listed by the applicable laboratories.

	MODEL	LABORATORY	TYPE	CERTIFICATION STANDARD
Î	6000TRS-CE	BSI	Gas Fireplace	BS EN 613:2001 (Amd 1)

Installation Regulations

Before installation check that local distribution conditions, nature of gas and pressure, and adjustment of the appliance are compatible.

This appliance must be installed with the rules in force, and used only in a sufﬁciently ventilated space. Consult instructions before installation and use of this appliance.

1

Approvals and Regulations

Heat & Glo • 6000TRS-CE • 2049-900 Rev. Q • 2/11

7

Image 7

Contents What to do if you smell gas ModelSafety and Warning Information Maintaining and Servicing Installing the FireplaceService Parts Log Set Assembly6000TRS-CE Service Parts List6000TRS-CE Valve AssemblyAppliance Certiﬁcation Installation RegulationsANY Such Action MAY Possibly Cause a Fire Hazard Location Centimeters Clearance Requirements StepLocating FireplaceFraming should be constructed of 2 X 4 lumber or heavier Step Framing FireplaceFlue System Approvals Step Installing Flue SystemIdentifying Flue Components DVP4 DVP6 DVP12 Straight UP Flue with ONE 1 90o Elbow Flue with TWO 2 90 Elbows Flue with TWO 2 90 Elbows Flue with Three 3 90 Elbows + H Venting Out the Rear Flue Installing Flue ComponentsVenting Out the Top Flue On the TOP of the heater Install Support BracketsInstalling Support Brackets Install FirestopsFlue Pipe & Firestop Flue Termination For Horizontal Terminations using the DVP-TRAPBe Positioned SO That the Arrow is Pointing UP DVP Termination Cap Outside of the building Alcove Applications Standing Pilot Ignition System Step Positioning Leveling, Securing FireplaceStep Gas Supply Line Step Gas Pressure Requirements Optional AccessoriesFinishing Installing the Ceramic Re Installing the TrimFractory LOG Placement Heat & Glo 6000TRS-CE 2049-900 Rev. Q 2/11 Placing the Ember Material Glass AssemblyDouble-check for gas leaks Review safety warnings and cautionsDouble-check for faulty components Step Before Lighting FireplaceStep Lighting Fireplace After the Installation Maintaining Servicing Your Fireplace Make Sure the Flames Standing Pilot Troubleshooting With the pilot lit, and the ON/OFF switch Placed in this Opening Limited Lifetime Warranty Limited Lifetime WarrantyWarranty Conditions